Front Hitch that Fits 2022 Ford E-450 Motorhome

Question

Question:

I have a Jayco motor home built on a 2022 Ford E-450 Super Duty 8 Cylinders 7.3L MFI 445 CID chasses. Do you have a front hitch for this vehicle?

asked by: Joe K

1

Helpful Expert Reply:

We have the Draw Tite front hitch part # 65053 that fits your 2022 Ford E-450 Jayco motorhome.

expert reply by: Jameson C

1

Answer 1

For your RV built on the 2003 Ford E-450 chassis, I recommend looking at the Curt Adjustable Width Trailer Hitch Receiver #C13702. This is a universal, adjustable trailer hitch designed specifically for use on RVs. It can be bolted to the vehicle…

view full answer...

Answer 2

I emailed my contact at SoftStart and inquired about the difference between the #SSR54FR and the SSRV3T. The products are exactly the same. The SSRV3T is simply SoftStart's internal part number which we refer to as part #SSR54FR.

view full answer...

Answer 3

I have a solution for you that I can provide, but we aren't going to have a custom fit hitch to fit a vehicle like what you referenced. I spoke to my contacts at Curt and Reese and the only styles of hitches that can be made to fit a service body…

view full answer...

Answer 4

According to my contact at Fantastic Vent the correct replacement lift motor to use in your vent is part #FVK6010-81, not item FVK-6050-80. The replacement motor does operate at a higher 17-RPM speed. Since your fan is of a lower rpm and manufactured…

view full answer...

Answer 5

Hey Michael, thanks for reaching out! The EcoHitch #EH57FR sits a little higher than the Curt #C52NR so it will give you better ground clearance for your 2024 Chevy Silverado 2500. The EcoHitch is a bit more recessed into the front bumper than the…

view full answer...

Answer 6

The Draw-Tite Front Mount hitch part #65067 installs so that it sticks out from the plastic air dam of the Ford. The hitch does not sit lower than the lowest part of the truck so it does not reduce ground clearance. I have attached a photo for your…

view full answer...

Answer 7

Yes, you can use the NOCO GEN On-Board Battery Charger #NOC34FR on your pickup's parallel batteries without disconnecting them. If your batteries were in a series, they would have to be disconnected. Since your batteries are parallel and maintain…

view full answer...

Answer 8

In order to charge your batteries wired in parallel with the NoCo Genius #329-GENIUS5 you'll want to connect the positive charge line to the positive terminal of the first battery and the negative line to the negative terminal of the opposite…

view full answer...

Answer 9

The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…

view full answer...

Answer 10

The 2" receiver for the EcoHitch item #EH87SR sticks out right through the middle of the air dam. I have attached a picture below that will show you what this front hitch looks like once installed. The EcoHitch Hidden Front Mount Trailer Hitch…

view full answer...

Answer 11

For a 2005 Ford E-450 RV Cutaway chassis you'd want the Draw Tite hitch part #65001 which is a confirmed fit. I attached an install video for this for you to check out as well.

view full answer...

Answer 12

The Draw-Tite Front Mount Trailer Hitch Receiver #65053 will fit on your 2022 Winnebago Spirit class C RV. This is most likely built on the 2021 Ford E-450 cutaway chassis as RV manufacturers begin with building new model years in March of the…

view full answer...