Depth Past Hitch Pin Hole of Curt RV Bumper 2 Trailer Hitch Receiver E-100
Question:
I have an RV-approved bike rack. The manufacturer states the hitch receiver “must be at least 3 3/8-inch deep past the hitch pin hole of the hitch receiver” so that the pin hole lines up. Can you provide this measurement? Thanks!
asked by: Daniel M
1
Helpful Expert Reply:
From the hitch pin hole to the rearmost part of the Curt RV Bumper 2" Trailer Hitch Receiver # E-100 is 3-1/2 inches.
So this will indeed work for your bike rack!
expert reply by:
Kyle S
1
Product Page this Question was Asked From
Curt RV Bumper 2" Trailer Hitch Receiver
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Trailer Hitch
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Carry Bikes While Towing a Travel Trailer
- Q&A: Can a Trailer Hitch be Installed on the Back of a Trailer
- Q&A: Recommended Weight Distribution System for a Minivan Pulling a Pop Up Camper
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: What Hitch Receiver do You Recommend for My 2022 Grand Design Imagine 2600RB Travel Trailer?
- Q&A: Recommended Slide Out Topper For A 138-1/2" Flange To Flange Measurement
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Q&A: Recommended Weight Distribution System For 2003 Nissan Xterra With Small Tent Trailer
- Q&A: Best Weight Distribution System for a MAC 206 LTD Folding Camper
- Article: Best Bike Racks for Electric Bikes