Parts Needed To Install A Trailer Brake Controller On a 2022 Jeep Wagoneer Without Factory Connector

Question

Question:

I saw your response for 2022 Jeep Wagoner electric brake controller and I have an additional question..... My Series 1 does not have a receptacle under the drivers side dash. I had my dealer confirm that. Now one might ask, why would a car company advertise a vehicle that can tow 10,000 lbs BUT, it wont come with a brake controller hookup. Can your company install a controller? Thank you.

asked by: Rich E

0

Expert Reply:

First we need to determine what all trailer wiring you will have on your 2022 Jeep Wagoneer. If you already have a 7-way the easiest option is to use the Tekonsha Prodigy RF Wireless Brake Controller # TK94FR which will use power off the charge line to power the brakes. It includes a wireless controller which will connect to a 12 volt outlet in your cab.

If you prefer a hardwired option and already have a 7-way I recommend installing the Redarc Tow-Pro Liberty Brake Controller # RED52VR with the Wiring Kit # 5506. The included wiring will need to be spliced into your 7-way and run to the front of the Wagoneer for power and splicing in the brake controller.

If you do not have any trailer wiring the Universal Wiring Harness w/ ModuLite and Brake Controller Harness # 22551 will allow you to install a 7-way on your Wagoneer. Then you will be able to connect the Redarc Tow-Pro Liberty Brake Controller # RED52VR with the Adapter # 331-TPH-017.

In the event you are located near our Wentzville, MO location you can contact our customer service department to discuss installation options.

expert reply by: Bud M

0

Answer 1

I was looking through the manual for the Suburban SW6DE water heaters and found that the Suburban replacement is similar but shorter than the Camco model #CAM02143. It looks like the original one used in that water heater was discontinued and…

view full answer...

Answer 2

For your 2022 Ram ProMaster 3500 I recommend the Redarc Tow-Pro Liberty Brake Controller #RED52VR. The main unit mounts in an out of sight location so only the control knob will be visible in the cab of your vehicle. The knob controls the braking…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

I have great news for you, you don't have to buy a new system to get a higher capacity. The spring bars on the Blue Ox SwayPro Weight Distribution w/ Sway Control part #BXW0750 can be swapped out for the Replacement 10K Spring Bars for Blue Ox…

view full answer...

Answer 5

Yes, you are looking for part number, #90195 for the Tekonsha Prodigy P3 Trailer Brake Controller and need the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers, #TK93VR too. This adapter plugs into the 4-pin connector on your…

view full answer...

Answer 6

For your 2004 Honda Odyssey you would not be able to use both Air Lift air bags #AL60740 and the SumoSprings #CSS-1145R. The air bags fit inside the coil springs on the bag so there would not be room to also have the SumoSprings. Even if they did fit…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 12

You do have the option to utilize the air brakes on your 2023 Freightliner Cascadia to control electric trailer brakes using the Hayes Air Actuated Trailer Brake Controller, part #HA100400C. However, we mostly recommend just using an electric brake…

view full answer...