Will Coil SumoSprings Custom Helper Springs Fit 2020 Dodge Durango R/T

Question

Question:

I would like to confirm that product #CSS-1145R fits 2020 Dodge Durango R/T AWD. Thx

asked by: Wayne

0

Expert Reply:

Yes, the Coil SumoSprings Custom Helper Springs # CSS-1145R will fit your 2020 Dodge Durango R/T. If you want to add them to the front as well the # CSS-1125F is also available.

expert reply by: Robin H

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Yes, the Coil SumoSprings Custom Helper Springs #CSS-1145R are confirmed to fit your 2023 Toyota Highlander Limited Platinum. You should not have any issues for your warranty as it is a add on part and you are not modifying the vehicle components.…

view full answer...

Answer 4

Hey Ronnie, the correct Coil SumoSprings kit that fits your 2WD 2021 Toyota Highlander is the part #CSS-1125F.

view full answer...

Answer 5

I spoke with Super Springs about the Coil SumoSprings Custom Helper Springs part #CSS-1145R for your 2012 Toyota Highlander Hybrid. The issue is not that it is not a fit but rather they have not yet had a Hybrid model in to test them on. If you are…

view full answer...

Answer 6

Suspension enhancement can be used with your weight distribution and will help with rear end sag. So the #CSS-1145R that fits your 2008 Toyota Highlander would help. You'll need to set your weight distribution up again.

view full answer...

Answer 7

The most hidden trailer hitch available for your 2020 Dodge Durango is without a doubt the Draw-Tite Max-Frame Trailer Hitch Receiver #DT38MR. The 2" receiver for this Class III hitch will actually extend out through the bottom of the rear…

view full answer...

Answer 8

The #CSS-1168R and #CSS-1195F are only confirmed to fit the FWD models but that doesn't mean there aren't Coil SumoSprings for your 2023 Sienna AWD. To find the right size you will need to measure the gap between in the middle of the coil.…

view full answer...

Answer 9

The difference between the Coil SumoSprings Custom Helper Springs for Coil Spring Suspension part #CSS-1145R and part #CSS-1168R is that the CSS-1145R is designed for 4 wheel drive models and the CSS-1168R kit is designed for 2 wheel drive models.…

view full answer...

Answer 10

That's definitely some sag! As a first step, I'd look over the instructions for the weight distribution system you're using to ensure that the system is set up properly. If I had a dollar for everybody that's told us that there was no…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Will Coil SumoSprings Custom Helper Springs Fit 2020 Dodge Durango R/T

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching