How to Determine the Correct Replacement Support Arm Assembly for Solera RV Awning

Question

Question:

Will this work on grand design imagin 2020

asked by: Sandra R

0

Expert Reply:

In order to determine if the Replacement Support Arm Assembly for Solera Flat RV Awnings # LC281154 will work with your 2020 Grand Design Imagine, you will just need to measure the length of the wall-mount extrusion from top to bottom as shown below.

Once you have the measurement on-hand you can choose the correct support arm assembly or you can let me know and I'd be happy to find it for you.

expert reply by: Bryce D

0

Measuring for Replacement
(click to enlarge)

Answer 1

I checked with Lippert and asked if we could get just the part number you mentioned and they told me it's not available by itself. You'd need the entire assembly part #LC281154.

view full answer...

Answer 2

While we don't have a way of knowing what awning you have, I can tell you how to choose the right replacement support arms, so long as your awning is a Solera awning. To do so, all you have to do is measure the length of the wall mount, which…

view full answer...

Answer 3

We have replacement pitch arms for your awning with the part #LC266169 which fits either side of the awning. This would exactly what you'd need to get going!

view full answer...

Answer 4

Yes, the Replacement Short Arm Assembly for RV Awnings part #LC404523 is correct for a Solera V000436372 Awning.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The awning does act as the roof for the Solera Family Room #LC362235. If you plan on repairing your fabric please use the Repair Tape #CAM42623 rather than duct tape. This tape is specifically designed for use on the awning material and will not dry…

view full answer...

Answer 7

If what you have now Chad is pretty flat at 26 inches then the best replacement size would be 25-1/4 inches like you mentioned. Since you wanted to increase the capacity you would want the part #e57SR which is for 4k trailer axles.

view full answer...

Answer 8

You definitely have a set of Lippert Equa-Flex equalizers on your 2019 Weekend Warrior and it looks like they are the part #LC279687 that you referenced. How often to grease the wet bolts depends on how much use the trailer gets. If you do not use it…

view full answer...

Answer 9

Yes, you could use leaf springs for a 4,000 lb axle, like part #e57SR (rated for 2,000 lbs each), with a 3,500 lb axle but it will make your ride a bit more stiff. The only times that a leaf spring would become damaged is if it is overloaded or has a…

view full answer...

Answer 10

Over time, any suspension components can fail and need to be replaced. Since you said a shackle broke now would be a good time to inspect all of the suspension components and replace any that show signs of damage or uneven wear. It is always best to…

view full answer...

Answer 11

It is possible to upgrade the leaf springs on a trailer to a higher rated set but I do not recommend this as it can create a rough ride. The better option would be to install the SumoSprings Trailer Helper Springs part #TSS-107-40 for overslung or…

view full answer...

How to Determine the Correct Replacement Support Arm Assembly for Solera RV Awning

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching