Race Ramps For 2023 Dodge Charger Redeye Widebody

Question

Question:

Which race ramp will work with a 2023 wide body redeye charger

asked by: Curtis W

0

Expert Reply:

According to my research, a 2023 Dodge Charger Redeye Widebody uses size 305/35-20 tires, which are 12 inches wide. For that size tire, the correct Race Ramps are the following:

- Race Ramps XT Ramps for Service and Display - 67" Long - 10" Lift # RR-XT-2

expert reply by: Kyle S

0

Answer 1

The Race Ramps Wheel Chock for Vehicle Service part #RR-WC-2 will fit on the main platform of the Race Ramps Heavy-Duty XT Ramps for Service and Display - 67" Long part #RR-XT-2-HD although it may hang off just a bit depending on the size of the…

view full answer...

Answer 2

Yes the Race Ramps XT Ramps for Service and Display #RR-XT-2 would work great with a 2001 Chevy Corvette. I attached a picture of a similar C6 Corvette on these ramps for you to check out as well.

view full answer...

Answer 3

The Titan 60ZX7000 brake actuator is a Model 60 actuator, and you do have the correct part for a replacement master cylinder: - Replacement Master Cylinder Assembly for Titan Model 60 and Aero 7500 Brake Actuators - Drum #T4395100 So this will work…

view full answer...

Answer 4

Go ahead and email me back with the picture of what you have and I can see if we can help. Worst case scenario you'd have to replace the coupler.

view full answer...

Answer 5

The best we can do is the replacement Master Cylinder part #DX66FR which replaces the whole thing. It sounds like that's what you are in need of since yours is leaking.

view full answer...

Answer 6

To know if your 2017 Ford F-350 has an in-bed puck system installed you'll just need to look and see if you have four rounded attachment points (usually covered up when not in use, like in the attached picture). If you don't see these in your…

view full answer...

Answer 7

What sets the EcoHitch #306-X7391 receiver apart from the other two options is that it's going to be completely hidden behind your bumper. The only portion that is visible is the 2 inch square receiver. So, if looks are important to you, this is…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Yes, the Kenda Karrier ST175/80R13 Radial Trailer Tire #AM31990 will indeed fit on the etrailer Hitch Mounted Spare Tire Carrier #e98ZR. The spare tire carrier will work with virtually any 4 lug, 5 lug or 6 lug wheel. The #AM31990 wheel uses the…

view full answer...

Race Ramps For 2023 Dodge Charger Redeye Widebody

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching