Trailer Stake Pocket Anchors & Ratchet Straps For ATV

Question

Question:

Hello. Do you have any recommendations for a retractable ratchet strap that will fit in the stake pockets of a trailer to easily secure a 1,700 lb SxS?

asked by: Ashif J

0

Expert Reply:

While there aren't any ratchet straps that fit directly in stake pockets of a trailer, we do have stake pocket tie-down anchors that you can use as a way to connect the ratchet straps; what you can use is the Stake Pocket Tie-Down Anchors # PK-SPTD.

Then for ratchet straps you can use something like the Bulldog Winch 13-Piece Ratcheting Vehicle Tie-Down Strap Set - 3,335 lbs # BDW20350.

expert reply by: Kyle S

0

Answer 1

You are correct. The #BDW20351 comes with 4 padded axle strap covers for paint protection while the #BWD20350 does not. Otherwise these strap kits are identical. Since you are planning to use this 2019 Corvette Grand Sport I would definitely choose…

view full answer...

Answer 2

Yes, you could switch to electric over hydraulic brakes and retain the air over hydraulic braking system. What you would have to do is have the main lines that come out of each actuator go to a hydraulic T fitting, obtained locally, that has a valve,…

view full answer...

Answer 3

The Buyers Products 15 Ton Pintle Hook with Mounting Kit #33710040 actually comes with the mounting hardware needed to get it installed but if you're needing to replace it you can find it with the Pintle/Combination Hitch Mounting Kit #3378520.

view full answer...

Answer 4

So I went out to the warehouse and measured the stake pocket anchor #TL2B and from the lip to the top of the pin hole is right at 6-3/4". As long as your stake pocket is really only 6" deep these will work just fine for you.

view full answer...

Answer 5

I do have a great option for you, however we do not have any standard 3,500 pound round tube axles available that match the dimensions you provided. For an exact replacement your best option will be to go through a local trailer shop or the…

view full answer...

Answer 6

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...

Answer 7

Usually loops for the safety chains are on the hitch receiver because a pintle hitch like the Buyer's Products #33710045 you referenecd often connects to a mount the B&W #BWPMHD14003 which slides into a receiver. If this isn't how yours…

view full answer...

Trailer Stake Pocket Anchors & Ratchet Straps For ATV

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching