Do You Carry Replacement Keys For the Rod Vault From Denver Outfitters?

Question

Question:

I have an older Rod Vault by Denver Outfitters. The lock is stamped A2123. Will the replacement key on your site A21231 work? Thanks!

asked by: Napoleon

0

Expert Reply:

As you have the older Rod Vault from Denver Outfitters you will need the Replacement Latch and Keys # TH85ME. This is needed as the key alone will not work as a replacement for the Original Rod Vaults before they were acquired by Thule.

expert reply by: Bud M

0

Answer 1

Since you have an older model from before Thule acquired this fishing rod holder the only way to get a replacement key would be secondhand. You can however replace the entire lock assembly with the Replacement Locking Lever Latch and Keys for Thule…

view full answer...

Answer 2

The replacement key for your Thule Rod Vault #TH87YV will depend on the number that is found on the lock cores of your carrier. If the number on the face of the lock core is N090 then the #THKEYN090 will be the correct lock replacement. If you find…

view full answer...

Answer 3

You will need the Replacement Latch and Keys #TH85ME for the Thule Rod Vault #TH27YV, or #TH87YV. This will also fit the original Rod Vault which came from Denver Outfitters like you have. Thule does not carry any replacement keys for the units…

view full answer...

Answer 4

What brand equipment did the lock core come from, Thule or Yakima? A Thule lock has the lock number engraved onto the face of the lock, next to the key slot. The number will usually be preceded by the letter N. A Yakima lock has the number stamped…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 9

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

As you have the older Rod Vault from Denver Outfitters you will need the Replacement Latch and Keys #TH85ME. This is needed as the key alone will not work as a replacement for the Original Rod Vaults before they were acquired by Thule.

view full answer...

Do You Carry Replacement Keys For the Rod Vault From Denver Outfitters?

Product Page this Question was Asked From

Continue Researching