What is Trailer Roof Vent # 9106-2756 Made Of

Question

Question:

What is the material this roof vent is made of. Is it steel, aluminum, or plastic

asked by: Ken K

0

Expert Reply:

I went and pulled a trailer roof vent # 9106-2756 from the warehouse. I used a magnet to check to see if it was steel and the magnet immediately stuck. This is not a fool-proof way to determine material but given the other characteristics of the vent, the black powder coat, that is a strong indication that it is steel.

We have a similar aluminum model, # RV-626-062.

expert reply by: Michael H

0

Answer 1

I don't see any reason you couldn't use the Redline 2-Way Pop-Up Roof Vent with Garnish for Enclosed Trailers #9106-2756 in the metal window panels of your Ford Transit Connect. People install these on similar surfaces pretty frequently…

view full answer...

Answer 2

The Redline 2-Way Pop-Up Roof Vent, part #9106-2756 adjusts in steps from fully closed to keep rain or air out, to fully open to let fresh air in. This vent can be installed with the vent facing either direction and being able to open the vent toward…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 5

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 6

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 7

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 8

Hey Paul, we have a Blue Ox base plate kit that fits your 2024 Nissan Versa with the part #BX1856. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle.…

view full answer...

Answer 9

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this point…

view full answer...

Answer 10

For the front legs of a Lippert Ground Control 3.0 kit the replacement front jack leg solution you'd need is the part #LC362485. This will allow you to reuse your current motor and bracket. There isn't a gear replacement kit for the jack…

view full answer...

What is Trailer Roof Vent # 9106-2756 Made Of

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching