Correct Kat's Heaters Custom Engine Block Heater for a Ram Promaster 1500 with 3.0 EcoDiesel

Question

Question:

Will this work for the 3.0 liter 4 cylinder eco-diesel in my Promaster 1500? Kats Heaters Custom Engine Block Heater - Frost Plug Style - 120V - 400 Watts - 28 mm Item # KH11455

asked by: Bill

1

Helpful Expert Reply:

I checked with Kat's and the correct Kat's Heaters Custom Engine Block Heater for a Ram Promaster 1500 with 3.0 EcoDiesel is part # KH11455 which installs into the rear center "RC" location.

expert reply by: Conner L

1

Correct Kat's Heaters Custom Engine Block Heater for a Ram Promaster 1500 with 3.0 EcoDiesel
(click to enlarge)

Answer 1

Class S chains are designed for vehicles with more restricted clearances in the wheel wells. Class U chains are for vehicles with more wheel well clearances. If your owners manual calls for Class S you would not have the clearance for a Class U…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

From what I can find on the 2022 Nissan Frontier, the plug for the brake controller that will let you use a harness like the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers #3050-P is located just above the OBD connector, taped tight…

view full answer...

Answer 6

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

view full answer...

Answer 7

Thanks for reaching out, Scott! The Blue Ox Base Plate Kit #BLU74FR on our site is actually the same thing as the Blue Ox part number BX2418 and I like that removable pin style much more than the etrailer Classic Base Plate Kit #e98945 with the fixed…

view full answer...

Correct Kat's Heaters Custom Engine Block Heater for a Ram Promaster 1500 with 3.0 EcoDiesel

Product Page this Question was Asked From

Continue Researching