Replacement Suspension Enhancement With/Without Internal Jounce Bumpers For A 2015 Ford F-150

Question

Question:

I have a 2015 f150 that has kit 57284 without internal jounce stops. Can I replace with the bags that do have the stops? And can I get the part numbers for both with and without?

asked by: Tyler

0

Expert Reply:

Sure you can. To replace your AirLift Load Lifter 5000 system on your 2015 Ford F-150, you can use:

-For 2WD: Air Lift LoadLifter 5000 Air Helper Springs # AL57268 for a replacement without the internal jounce bumper,

-For 4WD: Air Lift LoadLifter 5000 Air Helper Springs # AL57385 for a replacement without the internal jounce bumper,

Or,

-For 2WD: Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers # AL88268 for a replacement with an internal jounce bumper,

-For 4WD: Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers # AL88385 for a replacement with internal jounce springs.

expert reply by: Bryce D

0

Answer 1

We do indeed offer an air suspension solution from Air Lift that will work on your truck and will be compatible with in bed hitches. The #AL88268 LoadLifter 5000 would be an excellent choice for your truck. It's a no drill installation that…

view full answer...

Answer 2

The best choice of rear axle suspension kit for your 2018 F-150 will depend on the type of towing or hauling you're doing. All rear-axle kits for your 4WD F-150 appear on the linked page. If you are routinely hauling cargo loads of widely…

view full answer...

Answer 3

The part number for the Model 267C1.5 air bag that fits the #F2600 kit is #F6781. It does not have an internal jounce bumper in it like some models do. Per the installation instrutions of the #F2600 kit the factory jounce bumper should be…

view full answer...

Answer 4

The Firestone air bags do not have the jounce bumper that the Air Lift kits have. You want to always keep a minimum of 5 psi in the bags at all times, but at that minimum air pressure you still could bottom the suspension out in theory with enough…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…

view full answer...

Answer 11

Hey Michael, thanks for reaching out! The Timbren Active Off-Road Bumpstops #T28GR you installed on your 2018 Ford F-150 unfortunately have that reputation among users (although Timbren claims their systems provide a smooth ride). Because of this…

view full answer...

Answer 12

If you are considering Timbrens like the #TDR1500DQ and the SumoSprings like the #SSR-307-47 for your 2022 Ram 1500 4x4, I recommend the SumoSprings #SSR-307-47. The SumoSprings will offer the same quality as the Timbrens in terms of suspension…

view full answer...