Will Yakima EXO Swing Away Cargo Carrier Swing Out to Driver Side  

For a 2023 Ford Bronco Sport I recommend the Curt Trailer Hitch Receiver #C76HR. The installation is super easy, but will require you to slightly notch out the fascia a bit to fit the receiver tube. I've attached a short video below where the…

I have a similar pivoting hitch adapter to the Kuat you mentioned that will work great for you but the #PVD20B only works with Kuat bike racks according to Kuat. The Yakima BackSwing Swing Away Hitch Extender part #Y02483 can be used with cargo…

I have a great solution for you, but you cannot install a hitch accessory in the tube at the end of the Curt carrier part #C18151 that you referenced. Instead check out the Hollywood Racks Sport Rider SE Bike Rack and Cargo Carrier part #HR1400Z-85…

A lot of the steel cargo carriers do use a lot of the same features and so what typically differentiates them are subtle things like the hitch pin used or the height of the wall used to contain the cargo. If you're in the market for a standard…

You are correct there is a weight advantage for aluminum, item #C18100, over steel, item #CC-100, but the biggest reason aluminum is considered over steel, for most of our customers, is corrosion resistance and appearance. You do not need to upkeep…

I recommend the Kuat Pivot Swing Away Hitch Extender part #PVP20B. The Kuat Pivot Swing Away will allow you to attach a cargo carrier or bike rack to a 2" trailer hitch receiver tube opening and then pivot that accessory out 90 degrees to clear…

The Kuat Pivot 2 Swing Away Hitch Extender for Bike Racks - 2" Hitches - Driver's Side #PVD20B is individually rated for 250 lbs tongue weight. If your trailer hitch receiver has a tongue weight rated for less than 500 lbs, then you will…

No, the Yakima EXO Swing Away Storage System #Y74ZR or any combination/version of the Yakima EXO Swing cannot be swung to the drivers side. This is done by design for safety purposes. The reason for this is because by swinging to the passenger side,…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…