Mounting Bracket for TecNiq Premium Slim LED Strip Light

Question

Question:

How would I install this light?

asked by: Chris A

0

Expert Reply:

The Premium Slim LED Strip Light # TN66ZR can be installed using mounting clips. We have these available in a few different orientations so you'll just need to choose from the following:

Flat Mount - # TN22VR
45 Degree Mount - # TN34ZR
90 Degree Mount - # TN54ZR

Attached are some review videos for you to check out!

expert reply by: Jon G

0

Answer 1

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…

view full answer...

Answer 2

The etrailer Enclosed Trailer Transition Plate #e32JR is the only transition plate we carry and it does have a working load limit of 1,000 lbs. We have tested this transition plate extensively, and have found that it holds up well, even when loading…

view full answer...

Answer 3

In regards to the etrailer Enclosed Trailer Transition Plate #e32JR, the end plates are not designed to be swapped. There are pre-drilled holes in the end plates and center plates, which would not line up correctly if the end plates were swapped.…

view full answer...

Answer 4

The etrailer Enclosed Trailer Transition Plate #e32JR will work very well for loading and unloading motorcycles. It has a working load limit of 1,000 lbs so even with your 850 lb bike, you are well within parameters weight capacity wise. Especially…

view full answer...

Answer 5

The screen itself on an RV camera system monitor isn't a replaceable part and would require a complete replacement of the whole monitor. If you have a Voyager WiSight 2.0 system then you would need part #ASA87FR for the 4.3" monitor. For a…

view full answer...

Answer 6

As it turns out, almost all trailer roof vents are 14" X 14", +/- 1/4". Your best choice is the MaxxAir #MA00-335001 Universal Replacement Lid. The continuous hinge versions are better than the 3-tab versions. The hinge on this unit is…

view full answer...

Answer 7

Thank you for the information you provided, and I'll start by telling you that as a general rule it is a good idea to follow the recommendations of the vehicle manufacturer in regards to towing. Do you HAVE to use a weight distribution system if…

view full answer...

Mounting Bracket for TecNiq Premium Slim LED Strip Light

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching