Does Lippert SolidStep Steps Install on Trailers with Wood Subfloors

Question

Question:

The instructions mention wood floor or laminate floor. Are they referring to the floor covering or the actual sub flooring? I thought all trailers had wood floors?

asked by: Charlie C

1

Helpful Expert Reply:

That specific portion of the install instructions of the SolidStep Manual Fold Down Steps part # LC791574 refers to the floor covering. Underneath that RVs do all have wood sub floors.

expert reply by: Jameson C

1

Answer 1

Most likely, yes, the SolidStep Manual Fold-Down Steps #LC791574 would fit without removing the frame mounted steps under the entry door. Customers have done this before, see picture. I have included a link to a video review of these steps for you.

view full answer...

Answer 2

You will be just fine with the SolidStep Manual Fold-Down, #LC791574. This is designed to replace the trim plate. Please see the attached installation video to get a complete visual the installed arrangement. If installed properly your door will…

view full answer...

Answer 3

The unit itself is about 10-1/2" in depth when in the upright position. How that translates to depth inside the RV is dependent on installation. This mounts to the threshold of doorway with slight adjustment available. If you set further back on…

view full answer...

Answer 4

I checked with my contact at Lippert and the only two SolidStep Lift Assist Kits currently available both attach to the left hand side of your entry door. If you have a 26" - 29" wide entry door you will need the #LC733937 and for 30"…

view full answer...

Answer 5

Since you have a distance of 36 inches from the threshold to the ground the correct SolidStep you need is the part #LC791574 as it has a height range of 35 to 44 inches from the threshold to the ground.

view full answer...

Answer 6

You will be able to close your screen door with the Lippert SolidStep #LC791575 on your trailer; I've added a pair of customer photos that we received which show you the step on and their screen doors closed. You will need to make sure the steps…

view full answer...

Answer 7

The SolidStep Manual Fold-Down Steps for 26" to 29-7/8" RV Door Frames - Quad - Aluminum #LC791574 will work fine with most screen door bars like the Camco Deluxe RV Screen Door Cross Bar - 21-1/4" long to 28-5/8" long - Aluminum…

view full answer...

Answer 8

I pulled the Lippert SolidStep RV Steps #LC791574 and took some measurements to clear up any confusion. The mounting bracket (part that attaches to the floor) is 21" wide and the the brackets that sit against the door flange can be adjusted by…

view full answer...

Answer 9

The SolidStep Manual Fold-Down Steps part #LC791574 would be correct for your Grand Design Reflection 337RLS as it works with doorways between 28" - 30" and entry height from 35" - 44". This is an excellent upgrade for your RV and…

view full answer...

Answer 10

I spoke with the manufacturer to ensure the measurements were correct and found that the chart on the page for #LC432690 is incorrect. It does require 27-1/2" of space for the mounting brackets. Both the #LC432690 and #LC432696 will be too big…

view full answer...

Answer 11

The TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear #TLA8102 have a height of 16-1/2" from the top of the mounting bracket to the bottom of the steps when fully retracted. This is the same for the #TLA8103 since they both use the same…

view full answer...

Answer 12

I wish we could get what you need but apparently it's old enough our current options won't work. This means that you're going to have to upgrade to the Fan-Tastic Vent Roof Vent w/ 12V Fan and Remote #FV807350 to have a functional roof…

view full answer...

Does Lippert SolidStep Steps Install on Trailers with Wood Subfloors

Product Page this Question was Asked From

Continue Researching