Recommended 1,200 - 1,500 lb Side Mount Boat Trailer Jack Made in USA

Question

Question:

Could you tell me which 1200 to 1500 lbs jacks are made in the USA?

asked by: Ralph

1

Helpful Expert Reply:

The only side mount trailer frame jacks made in the USA we currently offer are from Dutton-Lainson such as the Pull Pin, Easy Swivel Trailer Jack part # DL22580 which has dual wheels for easier operation. It also has a 1,500 lb weight capacity with zinc plating for use on boat trailers.

I have attached a full list of our Dutton-Lainson side mount jacks below as well.

expert reply by: Conner L

1

Answer 1

I have included a dimensional drawing of the Dutton-Lainson Round Swivel Jack #DL22335 that shows the overall extended height of the jack at 40-5/8" tall. This measurement is from the bottom of the wheel to the top of the jack when extended.

view full answer...

Answer 2

When fully retracted, or collapsed the jack is 28.58 inches tall, and 38.42 inches tall when extended as shown in the provided diagram. I've linked you to a product description video featuring the #ORJW1SU ARK Extreme Off-Road Ratcheting Trailer…

view full answer...

Answer 3

Unless you want to completely clean out every bit of grease you will need to stick to a LMX red grease like item #L11390 that comes with the CE Smith Trailer Idler Hub Assembly item #CE13515. You can use your blue marine grease but you can't mix…

view full answer...

Answer 4

What you have there is a Dutton Lainson jack. There is no longer a direct replacement jack, but you can use the #DL22580 which will be an upgrade. This is a swivel jack with a 1,500 lb capacity and 12" of lift. This has dual wheels for easy…

view full answer...

Answer 5

There are some Dutton-Lainson trailer jacks that are made in the USA as well as a few that are not. Any jacks that we carry that are made in the USA have that as part of the description to help set them apart. Currently we have the following options:…

view full answer...

Answer 6

I can see you have a Fulton Bolt-Thru Trailer Jack so you can replace this with the Fulton Bolt-Thru Swivel Marine Jack part #FXP10W0301 which is a direct bolt-on fit and has a 1,200 lb weight capacity. Then for the Fulton XLT1401 Winch, I recommend…

view full answer...

Answer 7

I went out to the warehouse and pulled one of the Pro Series Snap-Ring Swivel Jacks, #PSEJ10000101, to measure for you. I added dimensions to a photo I took of the mounting plate for you to use to see if the mounting pattern will match up to your…

view full answer...

Answer 8

I reached out to my contact at Dutton-Lainson and the Dutton-Lainson Covered Hand Winch - 2 Speed - Freewheel - 25' Strap - 2,600 lbs #DL17085 will mount the same as your current DL1802A #DL14627. With that said the #DL17085 will be about…

view full answer...

Answer 9

Yes, the Swivel Marine Trailer Jack with Caster Wheel - Bolt On - Sidewind - 12" Travel - 1,500 lbs #DL67MR is the same as the DL22802. #DL67MR is our part number and the part number from Dutton-Lainson is 22802.

view full answer...

Recommended 1,200 - 1,500 lb Side Mount Boat Trailer Jack Made in USA

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching