Does The Master Cylinder Assembly Need Removed Before Welding Actuator # T4830300?
Question:
Do I need to remove the parts inside while welding it
asked by: Anthony
0
Expert Reply:
I do recommend removing the Master Cylinder Assembly # T4749501042 from the Dexter Brake Actuator # T4830300 before welding it in place. This will ensure you do not melt the inner boot on the front of the master cylinder. This assembly is only held in place by 4 bolts and removes easily.
expert reply by:
Bud M
0
Products Referenced in This Question
Replacement Master Cylinder Assembly for Dexter Model 10 and Model 20 Brake Actuators - Disc
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Master Cylinder
- Dexter
more information >
Product Page this Question was Asked From
Dexter Brake Actuator w/ Drop - Painted - Disc - 2-5/16" Ball - Weld-On - 12,500 lbs
- Brake Actuator
- Surge Brake Actuator
- Straight Tongue Coupler
- Weld-On
- 12500 lbs GTW
- 2-5/16 Inch Ball Coupler
- Disc Brakes
- No Lockout
- Dexter
more information >
Continue Researching
- Q&A: Difference Between Demco and Dexter Replacement Hydraulic Actuator Shocks
- Q&A: DA91 Demco Disc Brake Actuator for 2-5/16 Hitch Ball with Electric Lockout Needed
- Q&A: Replacement Brake Actuator for Global Direct GDC-80
- Q&A: Replacement Pontoon Boat Trailer Surge Brake Actuator With Drop Coupler
- Q&A: Mounting Hole Dimensions of Demco DA91 Surge Brake Actuator
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Q&A: Replacement Hydraulic Drum Brakes for Dico 15638
- Q&A: Can Titan Model 10 Actuator be Converted to Disk Brakes from Drum