Best Way to Stabilize Hitch Mount Bike Rack for E-Bike

Question

Question:

Hello, I’m looking to stabilize a hitch mounted bicycle rack carrying a heavy fat tire bike. Do you sell a hook that can attach to the wheel well of my sedan Audi A6? The alternative I’m considering is a Stanley suction cup that fits a 1” strap. Thanks

asked by: Ed S

0

Expert Reply:

Your best option is the Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories # 18050. This uses a hook that's meant to hook onto the truck so it isn't necessarily designed for the wheel well, but you might be able to get creative with it.

expert reply by: Jon G

0

Answer 1

The frame not being exposed isn't a big issue since it's just covered up with some corrugated plastic sheeting that can easily be pulled down and cut to fit in accessories. The real issue is going to be with the bumper since it sits…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Good morning Brenda. We do offer a trailer hitch for your 2016 Subaru Forester PZEV. The Draw-Tite #DT82MR is not the correct hitch though. That one is only for a 2010 or 2011 Volkswagen Amarok. Instead I recommend the Curt Class 3 Hitch #C13144…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

To install the Curt hitch part #C13144 on your 2015 Subaru Forester you will need to permanently remove the rear heat shield. I attached the install video you referenced as well as instructions that detail how this is done. Heat shields like what…

view full answer...

Answer 6

Trailer hitch #C11073 does not have the stop in the shank to prevent the installation of Class II accessories. The stop on other issues is a safety feature that prevents someone from accidently overloading the hitch. Also, on a Class I hitch, you are…

view full answer...

Answer 7

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 8

I have the answer for you. For your 2017 Volkswagen Passat the Tekonsha T-One Wiring Harness, #C79KR, is the confirmed fit for your SE model. The connector will plug in to your Passat's factory wiring and will provide a 4-pole flat connector for…

view full answer...

Answer 9

Glad to hear that you are already enjoying the Hollywood Racks Over-the-Top 2 Bike Carrier #HRF2 for your 2020 Subaru Forester! While using Velcro or zip ties are viable solutions, I recommend using the Strap Keepers for Yakima Trunk Mounted Bike…

view full answer...