Can You Back Up When Using Equalizer Hitch # EQ37120ET

Question

Question:

The dealer we bought the trailer from hooked up the Equal-i-zer weight distribution hitch with the spring bars. When I need to back this into a campsite, can I leave the spring bars connected or do I have to remove them?

asked by: Randy S

0

Expert Reply:

Yes, you can back up when The Equal-i-zer Weight Distribution System w/ 4-Point Sway Control # EQ37120ET is installed.

expert reply by: Noah E

0

Answer 1

You will want to choose the correct system based off of the loaded tongue weight of your trailer; this should typically be between 10% and 15% of the loaded weight of the trailer. I recommend using the Equal-i-zer Weight Distribution w/ 4-Point Sway…

view full answer...

Answer 2

Since there can be many different wheel/hub sizes for campers, I cannot tell you what size you have on the 2015 Lance camper. In order to determine the torque rating for the lug nuts on your trailer you can check out the attached chart. The torque…

view full answer...

Answer 3

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

The correct Roadactive kit that fits your 2023 Ford F-150 is the part #RAS3611-YHD. I really like the RAS kits as they basically don't have any downsides. You get the adjustable support, an easy install, no maintenance, and actually improves…

view full answer...

Answer 8

Yes, the Curt Custom Fifth Wheel Installation Kit for Ford #C93WR will work just fine with the Demco Autoslide 5th Wheel Trailer Hitch w/ Slider #DM8550040.

view full answer...

Answer 9

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 10

Thanks for reaching out, Steve! Both Air Lift LoadLifter 5000 kits, parts #AL47PD and #AL82WQ, fit a 2021 Ford F-150 4WD. The only difference is whether your truck has the CCD (Continuously Controlled Dampening)/Onboard Scales, or the PowerBoost…

view full answer...

Answer 11

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 12

Personally I feel like the Demco Autoslide 5th Wheel Trailer Hitch #DM8550040 is the best option for your 2021 Nissan Titan towing a 2011 Forest River Rockwood 8265WS. The Autoslide will move back up to 22-1/2" when you turn to give you the…

view full answer...

Can You Back Up When Using Equalizer Hitch # EQ37120ET

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching