Trailer Alignment Correction For a 26 RV Travel Tailer

Question

Question:

I have a tandem axel 26ft TT. My rear drivers side tire is wearing uneven. I just checked my wheelbase measurements and my drivers side is 35.5 inches and my passengers side is 35 inches. I assume this is causing my uneven wear issue. Would the Lippert Correct Track System be a good choice? Thinking about installing this to correct alignment.

asked by: Pete T

0

Expert Reply:

The Correct Track Trailer Alignment and Lift Kit # RR23QX will allow you to move the leaf spring bolts up to 1/2" forward and back to properly align your axles. Do note that this kit will raise your suspension by either 1-1/4" or 2-1/4", so you may need to make an adjustment on your hitch to keep the trailer level when towing.

You may consider having your suspension inspected to verify there are no damaged components that are causing the wheelbase to be off and your uneven wear on your tires.

expert reply by: Bud M

0

Answer 1

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 2

I would be happy to. To flat tow your 2017 Ford F-250 you will need the following parts: Tow Bar and Safety Chains - etrailer XHD Non-Binding Tow Bar item #e84ZR Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit - Removable Arms item…

view full answer...

Answer 3

Hey David; I checked directly with Pace Edwards for you and can tell you that the rails on the Pace Edwards Switchblade Retractable Hard Tonneau Cover #PE46QJ will protrude just under 3/4" on both sides when installed on your Ford Super Duty…

view full answer...

Answer 4

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 5

Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see the axle tag in order to determine what you have so I…

view full answer...

Answer 6

Yes, going from a 4 leaf to a 6 leaf spring would add slightly to your ride height. For example, if the current 4 leaf spring has 3/8" thick leaves, and you go to a 6 leaf spring with 3/8" thick leaves, you would be adding 3/4" of…

view full answer...

Answer 7

Bronze bushings like the #D014-077-00 do not require reaming when installing a shackle bolt into them. The splines in the bolt might make it a little tight but that is on purpose and does not require enlarging.

view full answer...

Answer 8

Thanks for the pictures! Since your 2022 Grand Design Reflection 303RLS came with the CRE3000 equalizers you will need three of the MORryde X-Factor Crossmember item #MR33WR. It looks like you have the standard 3" wide frame hanger so all of the…

view full answer...

Answer 9

Thanks for the picture of your build sheet! It does look like the etrailer 6-Leaf Double-Eye Spring item #e94SR you purchased is the correct replacement spring. Feel free to email me back a picture of your suspension but unless you are flipping your…

view full answer...