bing tracking image
Q & A Icon

How To Hook-Up DC Wires/Fuses on Replacement Converter Parallax/Magnetek or WFCO RV Power Centers  

Question:

The DC distribution boards do not match and Im unsure how to proceed with wiring What is the proper fuse placement and wiring for the bottom of the panel? I know how the old panel is wired but the new one has more connector. Attached is a picture of the old board in its original state

0

Expert Reply:

In regards to the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part # PD4645V, the fused slots on the control board are very easy to hookup. If you're swapping out an old panel just make sure to label each of the wires before removing. Then, you can connect the old wires into the terminals on the new board with a screwdriver, just make sure you then assign the correct fuse to said wire. It does not matter which slots you places the wires in, just make sure the fuses match said wire from the old board. There could very well be more slots than your old board, they can be left blank and used latter down the road if needed.

That said, it's really best to seek professional installation of the panel or converter section if you need assistance as these should be carried out by a licensed professional .

expert reply by:
0
Conner L
How To Hook-Up DC Wires/Fuses on Replacement Converter Parallax/Magnetek or WFCO RV Power Centers
How To Hook-Up DC Wires/Fuses on Replacement Converter Parallax/Magnetek or WFCO RV Power Centers
(click to enlarge)

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>