Does the Pop & Lock Custom Tailgate Lock Come With Instructions

Question

Question:

Does this part have instructions ?

asked by: Ric D

0

Expert Reply:

Yes, the Pop & Lock Custom Tailgate Lock # PAL1100 will come with installation instructions. I have also attached the instructions below for your reference.

expert reply by: Robin H

0

PL1100 Instructions.
(click to enlarge)

Answer 1

Yes, the Du-Ha Truck Storage Box and Gun Case #DU10013 that you referenced has been confirmed as a fit for your 2006 GMC Sierra 2500HD Crew Cab so it would fit and work well for you.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

view full answer...

Answer 5

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The HappiJac Camper Tie-Downs #LC182906-182971 that fits your 2023 Chevy Silverado 2500 can be pieced out with the Replacement Front Anchor Plates #LC182872 being what you've referenced needing.

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 10

Yes, GM sometimes uses a red plug or dummy fuse in place of an actual fuse for the trailer battery charge circuit. I have attached a video on a 2004 Chevrolet Silverado that shows the red dummy fuse. You can move to the 2 minute and 20 second mark to…

view full answer...

Answer 11

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 12

Sometimes just use of new spring bars can update a weight distribution hitch to match the tongue weight (TW) of a new trailer, but in the case of your Equal-I-zer system, part #EQ37140ET, the highest-rated bars are the 1400-lb set #EQ90-01-1499 that…

view full answer...

Does the Pop & Lock Custom Tailgate Lock Come With Instructions

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching