Will MORryde X-Factor Crossmember Fit Standard Hangers

Question

Question:

Will this item work with standard shackles and hangers

asked by: Robert D

0

Expert Reply:

The MORryde X-Factor Crossmember # MR33WR does indeed work with standard shackles or hangers for installation.

expert reply by: Robin H

0

Answer 1

The bearing races on a trailer hub, like the Trailer Hub Assembly, part #8-258-5UC1, are removable, they are not built into the hub. I am including a link to a FAQ page on wheel bearings, races, and seals. Also, a link to a video of removing and…

view full answer...

Answer 2

I would be happy to and congrats on the new trailer. It looks like your 2024 Grand Design Reflection 320MKS tops out right below 14,000 lbs. I recommend the MORryde Cushioned 5th Wheel Pin Box for 11K to 14K Trailers w/ Lippert Rhino item #MR44HR.

view full answer...

Answer 3

If you currently have the Lippert 1621 5th Wheel Pin Box, #LC1191191, and want to replace with a MORyde, then the MORyde replacement will be the MORryde Cushioned 5th Wheel Pin Box - Lippert 1621 - 18,000 lbs, #MR74VR. This is designed for trailers…

view full answer...

Answer 4

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The length Dexter posts for their leaf springs is the flattened length, so with the 072-042 having a length of 26" you would want to compare that to our 25-1/4" long springs as we measure their length with the spring relaxed. The 3-Leaf…

view full answer...

Answer 7

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 8

To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of the…

view full answer...

Answer 9

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 10

The hangers you currently have on your trailer are ones I have run into before. That being said, I spoke with MORryde and the #MR27ZR will still fit your trailer, but there is a modification that will need to be made. You’ll have to trim according to…

view full answer...

Answer 11

Yes, axle spread and wheel base by definition are the same measurements. You will measure from the center of one axle to the center of the 2nd axle to determine what you axle spread is. This may be difficult as some wheels and covers will make this…

view full answer...

Answer 12

When replacing shackle straps they should be the same length as the ones that were previously on your tandem axle trailer; replacing them with longer straps will result in additional play in your trailer suspension which could lead to additional wear…

view full answer...

Will MORryde X-Factor Crossmember Fit Standard Hangers

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching