Trailer Bearings Needed For The Timbren Axle-Less Trailer Suspension System
Question:
Im looking at purchasing this axle system for my trailer. My current hubs are 5 x 4.5. I would like to use these but Im not sure of how to find bearing and spindle specs to compare. I basically would like to figure out if my current hubs will fit on the Timbrens and what would be required..
asked by: Julie B
Helpful Expert Reply:
The Timbren Axle-Less Trailer Suspension System # ASR1200S02 use the same inner and outer bearing # L44649. If your bearings match your hub is good to go. If your bearings do not match you will need The Easy Grease Trailer Hub and Drum Assembly # AKHD-545-2-EZ-2K.
This hub assembly has a bolt pattern of 5 on 4-1/2 inches and has a 1/2 inch diameter x 1-1/4 inch long wheel stud. This hub is pre-greased and comes with the bearings, races, grease seal, grease cap, and lug nuts. This hub has an inner/outer bearing # L44649 and will work with the Timbren Axle-Less Suspension System mentioned above.
I attached a review video link below.
Products Referenced in This Question
Easy Grease Trailer Hub and Drum Assembly for 2K Axles - 7" - 5 on 4-1/2 - L44649 - Pre-Greased
- Trailer Hubs and Drums
- Hub with Integrated Drum
- Easy Grease
- EZ Lube
- Pre-Greased
- L44649
- L44649
- For 2000 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 10 Inch Wheel
- 12 Inch Wheel
- etrailer
more information >
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.063 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension - Standard Duty - No Drop - 1,200 lbs
- Trailer Axles
- Rubber Spring Suspension
- Easy Lube Spindles
- No Hubs
- 1200 lbs
- Spindles Only
- Universal Fit
- No Drop or Lift
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Air Lift WirelessAIR Compressor System for Air Helper Springs - Bluetooth - EZ Mount
- Shop: etrailer Electric Trailer Brakes - 7" - Left/Right Hand Assemblies - 2,000 lbs
- Shop: Suspension Enhancement
- Shop: Trailer Wiring
- Shop: Gooseneck Hitch
- Shop: Exhaust
- Search Results: dexter 7 inch electric brakes
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Video: etrailer Trailer Hubs and Drums - Hub with Integrated Drum - AKHD-545-2-EZ-2K Review
- Shop: Air Lift WirelessAIR Compressor System for Air Helper Springs - Remote - Bluetooth - EZ Mount
- Shop: B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Shop: Timbren Rear Suspension Enhancement System
- Shop: Trailer Hub and Drum Assembly - 2K Axles - 7" Diameter - 5 on 4-1/2 - L44649 - Pre-Greased
- Shop: Dexter Trailer Hub and Drum Assembly for 2,000-lb Axles - 7" - 5 on 4-1/2
- Search Results: 25980ez
- Search Results: akebrk~2
- Shop: Trailer Hitch
- Search Results: 25580
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Trailer Tire Sizing
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Search Results: fender
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer jack
- Shop: Fifth Wheel Hitch
- Q&A: What is the Difference Between Load Range B and C Trailer Tires
- Search Results: jack
- Video: Choosing the Right Trailer Wiring
on Trailer Suspension Parts
