Replacement Filter Canister For Clearsource Ultra RV Water Filter Systems

Question

Question:

One of my canisters froze and cracked on this. Do you have a replacement or will I need to replace the entire system?

asked by: Tak W

0

Expert Reply:

We do have the Replacement Filter Canister # CS28FR for the Clearsource Ultra RV Water Filter System # CS87FR. This will include both the lower canister and the top section depending on what all you need to replace.

expert reply by: Bud M

0

Answer 1

It can most definitely help. The Clearsource Ultra RV Water Filter System w/ VirusGuard - 3 Canister - Outdoor #CS87FR will catch the larger parts of oxidized iron in the 5 micron filter. A sub micron filter like the .5 filter in the middle of this…

view full answer...

Answer 2

The Replacement VirusGuard Filter, #CS69FR is the replacement filter for Clearsource Nomad #CS67FR, Clearsource Ultra #CS87FR, and Clearsource Onboard Pro system #CS59FR. If you have Clearsource system then this is the needed replacement filter. The…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Replacement Filter Canister For Clearsource Ultra RV Water Filter Systems

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching