Replacement Motor for Ventline model PH 100 CFM Range Hood

Question

Question:

I need a replacement range hood motor 1.5a ccw 120 volt

asked by: LeRoy

0

Expert Reply:

For the PH100CFM the correct replacement motor is the part # BVD0278-00 that you referenced.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 4

Suspension enhancement can be used with your weight distribution and will help with rear end sag. So the #CSS-1145R that fits your 2008 Toyota Highlander would help. You'll need to set your weight distribution up again.

view full answer...

Answer 5

I checked with my contact at Ventline and for your PR-8 100-CFM range hood the correct replacement motor is the part #BVD0278-00. Then for the fan blade you will need part #BCD0409-00.

view full answer...

Answer 6

Sorry for any confusion Aaron, I can confirm that the 22" Wide Vent Hood #VE78SR is 18" deep as you can see in the picture below.

view full answer...

Answer 7

The Replacement Fan Motor for Ventline Range Hoods #BVD0278-00 will work well in the manner you stated. You can simply connect the ground wire and the power wire while wire nutting the 3rd wire for the same function. This simply will give you the…

view full answer...

Answer 8

I believe I have a solution for you. It sounds like you need the Replacement Fan Motor for Ventline Range Hoods #BVD0278-00. This is a 2 speed fan motor designed to fit Ventline Range Hoods which is what it sounds like you have. This is pretty…

view full answer...

Answer 9

The Replacement Fan Motor for Ventline Range Hoods #BVD0278-00 will definitely be the direct replacement for the Ventline PR-4 you are fixing, but the motor housing is not available separately, unfortunately. Below I have all the replacements parts…

view full answer...

Answer 10

PR-1 range hoods use a 110V fan motor, so the correct replacement fan motor for your Ventline PR-1 range hood is the Replacement Fan Motor for Ventline Range Hoods #BVD0278-00.

view full answer...

Answer 11

The PR1 Range hoods are 110 volt so you need the replacement 110 volt fan motor part #BVD0278-00. The fan blade is part #BCD0311-00.

view full answer...

Replacement Motor for Ventline model PH 100 CFM Range Hood

Product Page this Question was Asked From

Continue Researching