Will The Lippert Solid Stance RV Support Kit Fit Lippert Solid Step Electric Steps?

Question

Question:

Hello...can this be used on my Class A motor home with 2 step lippert power steps?

asked by: Don

0

Expert Reply:

Yes you can use the Lippert Solid Stance RV Step Support Kit # LC96BJ.

This support kit will work with steps 5" to 14" off the ground, and measures 22-3/4" wide x 2-5/8" tall x 4-1/2" deep when folded.

Attached is a review video for you to check out as well.

expert reply by: Bryce D

0

Answer 1

Hey Eric, so to find out if the Lippert Manual Pull Out Steps #LC432682 are going to work with your 2022 Forest River Rockwood Freedom Camper you're going to need to locate the space available underneath your camper that lines up with the door…

view full answer...

Answer 2

The 23-5/8 inch width is the widest point and is actually for the metal rod. The bracket width is 22-1/8 inches from edge to edge. I measured this product for you to confirm and have attached a photo to assist.

view full answer...

Answer 3

Really you're going to need to measure the distance where the leveling system is going to be installed. If that distance is more than 20', then you're going to want the 6 point Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling…

view full answer...

Answer 4

We don't have an install picture but what I can do is describe it. The portion of the #LC301704 with the round holes mounts to the bottom of the frame on your trailer with nuts and bolts or welding. They would need to be spaced at the width of…

view full answer...

Answer 5

We don't have an install video but what I can do is describe it. The portion of the #LC301704 with the round holes mounts to the bottom of the frame on your trailer with nuts and bolts or welding. They would need to be spaced at the width of your…

view full answer...

Answer 6

The Lippert Solid Stance RV Step Support Kit #LC96BJ will fit Lippert double and triple manual folding steps, and in regards to how it will fit, what you will need to do is check the space you have under your double step. You will need to have at…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Kenny, those bolts for the B&W Companion 5th Wheel Trailer Hitch #BWRVK3500-5W should be torqued to 40 ft. lbs. Also, the pivot arms would need to be torqued to 80 ft. lbs, the draw down bolt should be tighten to 60 ft.lbs and the arms should be…

view full answer...

Will The Lippert Solid Stance RV Support Kit Fit Lippert Solid Step Electric Steps?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching