What is the Nut Size to Tighten and Loosen the Super Grip Chock XL Wheel Stabilizer

Question

Question:

Want to get a better ratcheting wrench or use a standard socket. The adjustment nut fits 11/16inch ok and a 17mm wrench works as well. What is the actual size? Didnt see an answer in the FAQ but maybe in the reviews, didnt read them all. Thanks

asked by: Nick S

0

Expert Reply:

The nut size for the Super Grip Chock XL Wheel Stabilizer for Tandem-Axle Trailers and RVs # UF21-001094 is 17mm. I contacted the manufacturer to verify this.

expert reply by: Scott S

0

Answer 1

I always use the Super Grip Chock Wheel Stabilizer #UF21-001090 as a Set #UF21-001091. This will prevent the trailer from pivoting on the chocked tires. It will also allow you to use them to secure your camper at your site and while in storage. These…

view full answer...

Answer 2

We do have the panels separately. What you're looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

To be completely honest the sway control feature of the B and W Continuum part #BW78FR isn't nearly as advanced as the rest of the system. The advertised sway control of this system is in the head of the system between where the ball and the…

view full answer...

Answer 5

I can provide a partial solution. We do not have a hose longer than 12', but the MB Sturgis Propane Adapter Hose for Small Appliance - Disposable Cylinder Ports - 12', part #100284-144-MBS, and the MB Sturgis Sturgi-Stay T-Fitting for Type 1…

view full answer...

Answer 6

7k Dexter axles are a little annoying as they can have two different seals with only difference being the inner diameter. If the seal has an inner diameter of 2.250 inch you'd want the part #GS-2250DL or if instead you had the spindle diameter as…

view full answer...

Answer 7

You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the second…

view full answer...

Answer 8

To verify the correct strut arm for your 2017 Forest River Rockwood Signature Ultra Lite travel trailer I will need to know exactly what awing arms your camper has. The tag for the awning arm is going to be located inside the awning arm to protect it…

view full answer...

Answer 9

In regards to the Lippert Components High-Speed Power Stabilizer Jack like part #LC298707, the first thing I would do is check voltage on your battery to make sure it is above 12.4 volts. If it is not then you have a dead battery and it will need to…

view full answer...

Answer 10

The Valterra High Flow Water Regulator part #A01-1122VP will need to be installed on the city water inlet, on the exterior of the camper. This would be the only location that could protect the plumbing inside your camper. That said, I recommend you…

view full answer...

Answer 11

The Water Hose Brass Elbow - 90 Degree #37262235 actually doesn't have a regulator built into it which is why there is no psi range for it. For this same type of fitting that does have the regulator you'll need part #A01-2222 instead but it…

view full answer...