Class V Hitch and Towing Parts Recommendations for a 2013 Ford E-350
Question:
Im looking for a class 5 hitch setup for my 2013 Ford E350 Super Duty. 5.4L motor. Standard length.
asked by: Joseph D
Expert Reply:
The only Class V trailer hitch for your 2013 Ford E-350 is the Draw-Tite Ultra Frame Trailer Hitch Receiver # 41945 which is a custom fit so it bolts right up to your van without any drilling.
Then for wiring I recommend the T-One # 118551 for a 4-Way flat connection and then add the Universal Wiring Harness # ETBC7 and Extra Wiring # 10-2-1 for a fully-functional 7-Way if that's what the end-goal is.
Finally, if you're looking for a ball mount kit to complete a towing system I recommend checking out the B&W Tow & Stow 2-Ball Mount # BWTS10040B which gives you some flexibility in what you can tow and is rated for up to 10K for towing. I recommend picking up the hitch lock # 34061075-D to secure your investment.
Attached are some videos for you to check out.
Products Referenced in This Question
Deka Jacketed 2 Wire, 10 Gauge, Brake Wire - per Foot
- Wiring
- Wire
- Jacketed Wire
- 2 Wire
- 10 Gauge
- Deka
more information >
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
InfiniteRule Locking Pin for B&W Tow and Stow 10K and 14.5K Ball Mount - Stainless Steel
- Accessories and Parts
- Drop Hitch
- Trailer Hitch Ball Mount
- Locks
- Locking Pin
- InfiniteRule
more information >
B&W Tow & Stow 2-Ball Mount - 2" Hitch - 7" Drop, 7-1/2" Rise - 10K - Black
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- 2 Inch Ball
- 2-5/16 Inch Ball
- Two Balls
- Steel Ball
- Steel Shank - Matte Black
- Drop - 7 Inch
- Rise - 7 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- Class IV
- B and W
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Draw-Tite Ultra Frame Trailer Hitch Receiver w/ Cast Center - Custom Fit - Class V - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class V
- 1500 lbs TW
- 10000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: Distance Between Mounting Holes on Draw Tite Hitch # 41945
- Article: Trailer Wiring Diagrams
- Q&A: How To See If 2019 Acura RDX Has Plus 12v Power Provision Without Removing Interior Trim Panels
- Q&A: Hitch Recommendation for a Ford E-450 Bus
- Q&A: What Are the Mounting Hole Dimensions for Curt Trailer Hitch Receiver 14053
- Q&A: Brake Controller and Wiring Harness for 2014 Ford E-250 Van Not Pre-Wired For Trailer
- Q&A: Correct B&W Turnoverball Underbed Gooseneck Trailer Hitch for 2019 Ram 2500 Without Prep
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Which Trailer Hitch Fits on a Ford E-350 Van
- Article: Rooftop Cargo Carriers