Parts to Install Full 7-Way Wiring Kit on Trailer
Question:
I have a early 80s 14ft 4 ton Hudson equipment trailer that was given to me. Im doing a total rebuild of it and need a full wiring harness. It does have trailer breaks.
asked by: Jason P
Expert Reply:
To add a fully-functional 7-Way wiring kit on your 14' Hudson trailer I recommend the following parts:
Trailer Wiring 7-Way Upgrade Kit # HS381-9000
20 Ft 4-Way Trailer Wiring Harness - # A20WB
10 Gauge Wire - # 10-1-1
16 Gauge Wire - # DW02359-1
Heat Shrink Butt Connectors - Parts # DW05744-10 and # DW05745-10
The Upgrade Kit comes with a junction box that acts like a "hub" for all of your trailer wiring. This makes it easier to connect your wiring to the various functions as well as perform any troubleshooting in the future. The 20' wiring harness is what you'll normally use for a standard 4-Way trailer kit so you'll just cut off the 4-Way connector and install the wiring in the junction box. This comes with 2 brown wires for the running lights so you can route that function down both sides of your trailer.
You'll use the 10 Gauge Wire for your brake circuit and then the 16 Gauge Wire for a reverse signal if that light exists on your trailer. The Heat Shrink on the butt connectors will protect your wiring connections from the elements so you don't have to worry about them.
Attached are some review videos as well as a helpful article on how to wire a 7-Way plug and standard trailer wiring for you to check out.
Products Referenced in This Question
20 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 30" Ground
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 11 - 20 Feet Long
- Plug and Lead
- 4 Flat
- Optronics
more information >
Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 10
- Wiring
- Wire Connectors
- Butt Connectors
- 16-14 Gauge
- Deka
more information >
Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 10
- Wiring
- Wire Connectors
- Butt Connectors
- 12-10 Gauge
- Deka
more information >
Product Page this Question was Asked From
Wiring Kit for Hydrastar Electric Over Hydraulic Actuators
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Wiring
- Hydrastar
more information >
Continue Researching
- Q&A: Parts Needed to Wire Trailer With Electric Brakes
- Q&A: Parts Needed For Replacing Trailer Wiring On a 22 Equipment Trailer
- Q&A: How Do I Clean the Terminals in a 7-Way Connector
- Shop: Trailer Wiring
- Q&A: Installation of Trailer Wiring Harness Through Frame or Conduit on 6x12 Trailer
- Q&A: How to Wire Electric Brakes on a Tandem Axle Trailer
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Q&A: Recommended 7-Way Trailer Wiring Harness for Featherlite Car Trailer
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Adding Electric Over Hydraulic Disc Brakes