Replacement Brake Assemblies That Use 5-Bolt Mounting Pattern

Question

Question:

Looking for brakes for tz 50 whole assembly/ axle is dexter 69-109/ backing plate is 5 hole/ wheel is 6 lug / serial number is tz5016j-1485/. 12 inch

asked by: Daniel M

0

Expert Reply:

Since you have the 5-bolt backing plate it means the 12" Electric Trailer Brake Kit # AKEBRK-6 is what you're looking for. This works with 14-1/2", 15", 16", and 16-1/2" wheel sizes and axles rated for 5,200 lbs - 7,000 lbs. To install these you'll also need the mounting bolts and hardware # BRKH12.

Attached is an installation video for you to check out.

expert reply by: Jon G

0

Answer 1

I sent your axle serial numbers to Dexter and they informed me that your trailer has #12 torflex axle with rubber capacity of 7000 lbs from 12-7-2000. So you were correct that you have a 6k rated axle. The Dexter electric brake assemblies part number…

view full answer...

Answer 2

On Dexter 12" Nev-R-Adjust Electric Brake Assembly #23-458 the shoe pad thickness is 3/16 of an inch. Dexter says that you should replace the shoes if the material gets down to 1/16 of an inch thick or less.

view full answer...

Answer 3

The correct set of replacement brake assemblies for your AxleTek 12 inch assemblies is the kit part #AKEBRK-7-SA that you referenced. This kit is a pair of left and right assemblies that are an exact match to what you have that are also self…

view full answer...

Answer 4

Since the trailer was off of the ground it would not take much voltage to stop the wheels from spinning so they may be getting power but they may not be getting enough power due to a short or wiring issue. But 9 times out of 10 weak trailer brakes…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

The only difference between the Dexter Trailer Hub and Drum Assembly #42866UC3-EZ and the Dexter Trailer Hub and Drum Assembly #42866UC3 is that #42866UC3-EZ is designed to be used with #42 E-Z lube spindles and #42866UC3 is meant for regular #42…

view full answer...

Answer 7

If you already have brake drums you will not have to replace them unless they are damaged or became overheated and have discoloration on the inside armature surface where the magnet rides, grooves in the armature surface, or severe wear where the…

view full answer...

Replacement Brake Assemblies That Use 5-Bolt Mounting Pattern

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching