Correct Female Pipe For The Replacement Pipe For etrailer And Ram Mount Swivel Jacks

Question

Question:

Is TJP-FP58 the correct female part for the TJP-OP58 male part or is there a different one I should be using TJP-IP58-CTN or a different one? And is TJP-FP58 and its other part designed to handle a 7k pound trailer? Thank you.

asked by: Walt

0

Expert Reply:

Yes!

The corresponding female pipe for the Replacement Pipe for etrailer and Ram Pipe Mount Swivel Jacks # TJP-OP58 is the:

-Replacement Female Pipe for etrailer and Ram Pipe Mount Swivel Jacks # TJP-FP58.

Additionally, both of these parts are designed to work directly with the Square Pipe Mount Swivel Jack w Footplate # TJDP-7000-B, so yes it will handle your 7,000lb trailer just fine.

expert reply by: Bryce D

0

Answer 1

I've attached a dimensional drawing for the Ark XO Drop Down Corner RV Stabilizer Jacks #ARK87FR, which displays the measurements in mm and inches. If you need anything else please let me know and I'd be happy to help.

view full answer...

Answer 2

On a trailer electric brake assembly like the Dexter 6,000 Pound #23-105 you were looking at the magnet itself should be at the bottom. The arm that is attached to the magnet should then be located on the front side of the trailer (towards the…

view full answer...

Answer 3

I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…

view full answer...

Answer 4

The SeeLevel Sensor part #SE27VR that you referenced runs on 12 volts.

view full answer...

Answer 5

The grease cap part number that you referenced cross references to a drive in cap with a 2.44 inch outside diameter. If you have a standard cap then the Grease Cap, 2.44 inch OD Drive In, item #RG04-060, is the correct part. If you have a grease…

view full answer...

Answer 6

I am not entirely sure I understand your question. In regards to a breakaway system, the switch needs to have a separate battery for power according to most state regulations. You will need to check with your state's DOT but it is safe to assume…

view full answer...

Answer 7

Some different brand names of trailer breakaway kits do originate from a common source, and this is also true for items like jacks, landing gear and steps. There really is not a lot to distinguish one from another, since their component parts are…

view full answer...

Answer 8

As long as a qualified welder is used, a Safety Chain Attachment Loop like part #E950 could be welded to the receiver as shown in the photo I provided. Having an amateur welder weld it could result in the hitch being weakened. This would be the best…

view full answer...

Answer 9

So the install of a spindle like the #TRU97FR really needs to be done by a welder who has done the job before and has the special jigs for the job. It's a precision job and we can't recommend a method for it aside from taking it to someone…

view full answer...

Correct Female Pipe For The Replacement Pipe For etrailer And Ram Mount Swivel Jacks

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching