Troubleshooting An Atwood Levelegs System That Keeps Trying To Retract A Jack Leg
Question:
Atwood levelegg I have an 2007 Allegro Open Rd 34.5 TGA The left rear jack, 7.5k short will extend and retract When that jack is fully retracted the system does not recognize that it is fully retracted. The motor continues to run and the control panel sounds the alarm. Do you have any suggestions to fix this problem? If the entire leveling system has to be replaced are there any available that would use the same hardware? Thanks
asked by: Tony N
Expert Reply:
First I recommend trying to troubleshoot the issue by putting the system in error mode by disconnecting the affected jack from the power and pressing the RET and ALL buttons. Reconnect the jack to power and then manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack. Listen to ensure all jacks move when manually activated. Press RET and ALL to retract all jacks.
If this doesn't work and you can't get a replacement control panel from Lippert and need to replace the system you would have to replace everything. We currently carry the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote # LC675817 which would come with all the components you would need.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Curt Pintle Hook with 2-5/16" Ball - 2-1/2" Hitches - 20,000 lbs
- Shop: Trailer Hitch
- Shop: B&W Companion OEM 5th Wheel Hitch for Ram Towing Prep Package - Dual Jaw - 25,000 lbs
- Search Results: 45908
- Search Results: 94920
- Video: Curt Commercial Duty Trailer Hitch Installation - 2019 Ram 3500
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class V Commercial Duty - 2-1/2"
- Shop: MORryde RV Cargo Sliding Tray - 90" x 20" - 2 Way Slide - 60 Percent Extension - 800 lbs
- Shop: Replacement Lippert Control Panel with Amp Connector for 4-Point Leveling System
- Shop: B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Q&A: Recommended Replacement for Jensen JRV9000 RV Stereo
- Search Results: gnrk1108
- Q&A: Can 2019 Nissan Rogue Be Towed Behind a Motorhome
- Shop: B&W Tow & Stow Pintle Hook - 2-5/16" Ball - 2-1/2" Hitches - 10,000 lbs/16,000 lbs
- Shop: Towing Mirrors
- Search Results: ctg60~2090w
- Search Results: ts20056
- Search Results: rvk3600
- Q&A: Is There a Goose Box that Fits a Lippert Turning Point Pin Box
- Search Results: rvk3050
- Q&A: Replacement Slide-Out Motor For Klauber K01348D500
- Shop: Vehicle Air Mattress
- Q&A: Solution for Needing Replacement Parts for Atwood Levelegs
- Q&A: Should The Wheels Come Off The Ground When Leveling A Camper Or Trailer?
- Q&A: Solution for Replacement Leg for Discontinued Atwood Levelegs
- Video: Lippert Ground Control Replacement Leg Installation - 2015 Forest River Vengeance TT Toy Hauler
- Video: etrailer Trailer Jack MJ-1000B-GR Review
- Video: etrailer and Ram Swivel Marine Jacks Rebuild
- Video: Review of etrailer - Trailer Jack,Camper Jack - RVLG-RDBOX
- Video: Review of Lippert Components Power Landing Gear Repair Kit - LC146060
on Camper Jacks
