Distance Between Shank Hitch Pin Hole and Adjustment Hole Blue Ox Weight Distribution

Question

Question:

What is the length of the shank only for this assy? Center of hole to center of hole?

asked by: Paul N

0

Expert Reply:

On the shank of the Blue Ox weight distribution system part # BLU36FR that you referenced the distance between the hitch pin hole center and the adjustment hole centers is 9 inches.

expert reply by: Jameson C

0

Answer 1

The Blue Ox TrackPro Weight Distribution w/ Sway Control item #BLU36FR weighs 80 lbs.

view full answer...

Answer 2

Absolutely. Whenever the trailer weighs in at least half of the weight of the tow vehicle a weight distribution system is recommended. For your application I recommend checking out the Blue Ox TrackPro Weight Distribution w/ Sway Control #BLU36FR.…

view full answer...

Answer 3

I have just the perfect air helper spring upgrade for your 2023 Jeep Wrangler Unlimited! The Air Lift 1000 Air Helper Springs for Coil Springs #AL60829 provides 1,000 pounds of load-leveling support that will help improve safety and ride quality. The…

view full answer...

Answer 4

When it comes to installing a weight distribution hitch on your Coachmen Apex Nano you would first need to know what the maximum tongue weight capacity will be for the trailer. We would also need to know how much tongue weight you plan on hauling.…

view full answer...

Answer 5

To tow a trailer with your 2008 Honda Pilot, I recommend the Blue Ox TrackPro, part #BLU36FR. This weight distribution system can support tongue weights between 200 and 600 pounds and has a built-in sway control. You will definitely appreciate that…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

Yes, you will. The Reese Pro Round Bar Weight Distribution System item #RE34FR has built in sway control that will keep your trailer in line with your Ram when you make sudden moves or get passed on the highway by a semi. This system has a tongue…

view full answer...

Answer 8

The Curt MV Weight Distribution System part #C17050 does not have sway control so reversing is not as big of an issue although the trailer still needs to remain relative straight. If you need to turn and backup it is recommend to unhook the spring…

view full answer...

Answer 9

Assuming you're talking about the length of your shank being 16" long, then no the length of your shank will not affect the capacity of your weight distribution system. That being said, if you're looking for a complete system I recommend…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Distance Between Shank Hitch Pin Hole and Adjustment Hole Blue Ox Weight Distribution

Product Page this Question was Asked From

Continue Researching