Valve Stem Extension for Thor Freedom Elite 24FE Mercedes Sprinter

Question

Question:

What is your recommendation for valve stem extension for rear dual tires on Thor Freedom Elite Mercedes Sprinter?

asked by: Reid R

1

Helpful Expert Reply:

The Wheel Masters 4-Hose Inflation Kit - 16" to 19-1/2" Dually - Hub Mount - 135-Degree Bend # WM8001-135 would be the correct inflation kit for the dually setup of your Thor Freedom Elite. This will attach both of the valve stems to the center hub of the wheel which will make checking the pressure and inflating the tires very easy and convenient.

expert reply by: Jameson C

1

Answer 1

We have everything you need here. For your TPMS system, we have the TireMinder i10 TPMS for RVs and Trailers w/ Signal Booster, part #TM89FR. It has 4 sensors and can be used on rubber and steel stems. It includes an LCD monitor with visual and…

view full answer...

Answer 2

For wheels with smaller hand holes like your setup has we know the Wheel Masters 4 Hose Inflation Kit #WM8001-135 would work well. Check out the attached picture and you can see them installed on a similar style wheel.

view full answer...

Answer 3

The 135 degree hoses are not offered separately from the Wheel Masters 4-Hose Inflation Kit unfortunately. I wish I could tell you exactly what you need but these are not vehicle specific parts, they are universal therefore up to the installer to…

view full answer...

Answer 4

The access to the GMC Yukon 3500 with dual wheels is so limited that to my knowledge we have not had anyone install the Wheel Masters 4-Hose Inflation Kit #WM8001-135 on one. The inflation kits are typically sized by wheel rather than vehicle…

view full answer...

Answer 5

It sounds to me like either Wheel Master Inflation Kit can work for you. It more depends on how you wish for them to be installed and what will work best for your wheels. The #WM8001-135 can be installed onto the hubs, wheel covers, or wheel liners.…

view full answer...

Answer 6

I reached out to the manufacturer, TST, for you about the TST TPMS for RVs - 6 Tire Sensors #TST-507-RV-6-C and TST TPMS for RVs - 6 Flow Through Tire Sensors #TST-507-FT-6-C. I was told that for your set up, with rubber valve stems and steel valve…

view full answer...

Answer 7

With valve stem extensions like the part #WM8001-135 that you referenced we have a few options based on how they attach. These attach to the hub whereas other options would clip to a wheel cover if there was one present. Not all wheels have wheel…

view full answer...

Answer 8

We have a Lippert Components replacement slide motor that will work with the Schwintek system. It is the Lippert In-Wall RV Slide-Out Motor #LC236575. It is a gear ratio of 300:1. This is the correct replacement for the Schwintek IG420294X00096R.

view full answer...

Answer 9

While not required as it is a 5th wheel hitch, safety chains are always a good idea, including for the Curt CrossWing Lightweight 5th Wheel Trailer Hitch #C86JR. There are even specific chains and mounts for the CrossWing, the Curt Safety-Chain Loops…

view full answer...

Answer 10

We've checked with Jensen in the past and for your AWM970 RV stereo the simplest replacement solution is the Jensen part #JWM60A that you referenced.

view full answer...

Answer 11

If you'd be willing to cut off the Lance connectors and wire in 6-ways or 7-ways in place of them we can help, but at this time only Lance can get you that specific connector. You could use the part #A7WCB with the #PK12-707E and you'd have a…

view full answer...

Answer 12

Square axles normally don't have spring seats like a round axle but do have a hole for the leaf spring bolt to fit into. Take a look at the CE SMITH #CE33201GA-HUB for a visual. The U-bolt mounting kits will have a hole in the center for the…

view full answer...

Valve Stem Extension for Thor Freedom Elite 24FE Mercedes Sprinter

Product Page this Question was Asked From

Continue Researching