Correct Lockout Kit for Demco Hydraulic Brake Actuator DA86

Question

Question:

Can I use item#DM5863 with iem#DM72VR? Please explain why or why not

asked by: Raymond L

0

Expert Reply:

Yes, the Reverse Lockout Solenoid Kit for Demco DA66B Hydraulic Brake Actuators part # DM5836 will work great with the Demco Hydraulic Brake Actuator part # DM72VR.

expert reply by: Conner L

0

Answer 1

I recommend using the Demco Hydraulic Brake Actuator #DM72VR with the Reverse Lockout Solenoid #DM11993. This solenoid will require you to have a 5-Way Flat Trailer Connector #HM47910 on your trailer. This solenoid will become activated when your…

view full answer...

Answer 2

Demco surge brake actuators require a Reverse Lockout Solenoid #DM11993. They do not have the ability to use a reverse lockout key.

view full answer...

Answer 3

The wires on the Reverse Lockout Solenoid Kit #DM5836 are for the ground and the reverse light circuit. It does not matter which wire you use for the two connections, it will work either way. If you take a look at the installation video below…

view full answer...

Answer 4

To determine why you do not have any power on the blue brake output wire, I recommend starting at your brake controller. First, make sure the brake controller is on and receiving power. Most brake controllers have 4 wires, blue (brake output to…

view full answer...

Answer 5

If you disconnect the trailer connector when backing up do the brakes still lock up? What I bet is happening is that your trailer reverse light circuit is shorting out to the brake output circuit which is causing the brakes to apply every time you…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

We have a really great kit that comes with everything you'd need to convert your 2021 Vanleigh Pinecrest 335RLP from tandem 6k drum brakes to electric over hydraulic disc brakes with the HydraStar Disc Brake Kit w/ Actuator for Triple Axle…

view full answer...

Answer 8

A drop axle certainly can make it tough to reach the star wheel adjuster on a drum brake. The adjuster spoon tool we offer #W80630 has a 90-degree bend that will often let you get access to the adjuster even on a drop axle. Essentially you will need…

view full answer...

Answer 9

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 10

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 11

That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference. You…

view full answer...

Answer 12

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Correct Lockout Kit for Demco Hydraulic Brake Actuator DA86

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching