Replacement Equalizers for 1995 Ranger Bass Boat Tandem Axle Trailer

Question

Question:

I am looking to replace the equalizer and shackles on a 1995 Ranger bass boat trailer with tandem axles. The springs are 1 3/4” double eyed, the axle spacing is 33”, the equalizer is 7 3/4” X 2 7/8”. Is the suspension kit to purchase K71-449-00? The shackle straps I have currently appear to have a slightly longer length between openings than the 2 1/4” in the kit. They are more like 2 5/8”! The longer length may be due to wear. Will the slightly shorter shackles that come with the kit be an issue? Currently the tires come close to the fenders an could stand to have more spacing. Thanks for your time.

asked by: Mark K

1

Helpful Expert Reply:

Based on the dimensions you have provided the best fit would definitely be the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double-Eye Springs # K71-449-00. These equalizers are an exact match for your current equalizers. You should not have an issue with the shackle straps being 3/8" shorter and it will slightly raise your suspension.

I have attached an installation video for your reference.

expert reply by: Robin H

1

Answer 1

We have a solution for you but because your axle is already over slung and you have taller hangers in place, we are limited in options. From the images you forwarded, you have a T44 axle. I recommend the Correct Track Trailer Alignment and Lift Kit…

view full answer...

Answer 2

The shackle straps of the #e99ZR are shorter at 1-3/4 inches than what you have now but that wouldn't be an issue. The slight length change would not be a problem.

view full answer...

Answer 3

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but…

view full answer...

Answer 4

To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of…

view full answer...

Answer 5

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 8

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 9

Yes, going from a 4 leaf to a 6 leaf spring would add slightly to your ride height. For example, if the current 4 leaf spring has 3/8" thick leaves, and you go to a 6 leaf spring with 3/8" thick leaves, you would be adding 3/4" of…

view full answer...

Answer 10

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

view full answer...

Answer 11

The hangers you currently have on your trailer are ones I have run into before. That being said, I spoke with MORryde and the #MR27ZR will still fit your trailer, but there is a modification that will need to be made. You’ll have to trim according to…

view full answer...

Answer 12

When replacing shackle straps they should be the same length as the ones that were previously on your tandem axle trailer; replacing them with longer straps will result in additional play in your trailer suspension which could lead to additional wear…

view full answer...

Replacement Equalizers for 1995 Ranger Bass Boat Tandem Axle Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching