Can Adjustable Ball Mount with Sway Control Tab # 7390 be Used with Left or Right Side Sway Control

Question

Question:

Can the sway bar plate be either left or right mounted for a Curt Swat BAr

asked by: Charles S

0

Expert Reply:

Yes, on the adjustable ball mount with sway-control tab you can use it with either left or right side sway control attachments. You just have to turn the adjustable part 180 degrees (upside down) to move to the opposite side.

expert reply by: Michael H

0

Answer 1

In general, if C-channel frame members face inward - meaning that the two open parts of the Cs face each other - then bolt-on chain hangers like #RP58305 can allow installation of a WD system. Standard clamp-on hangers like those in Reese system…

view full answer...

Answer 2

All of our friction sway control unit

view full answer...

Answer 3

To tow your trailer level based on the dimensions you listed you are correct, you would want a ball mount that has 4-1/4 inches of drop. The closest drop we have would be 4 inches like the part #2753. Since the rear suspension of your Honda Pilot…

view full answer...

Answer 4

We totally understand and can relate to being stressed about trailer sway. Even in small doses it's scary and the fact it can lead to a very dangerous outcome if it gets out of hand means it's worth trying to eliminate. Based on the type of…

view full answer...

Answer 5

Yes, the spring width would matter when using the Dexter Over Under kit part #K71-384-00 that you referenced. If you check out the picture I attached you'll see that if the spring was too wide the u-bolt holes of the plate wouldn't fit around…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

view full answer...

Answer 9

The ideal height will actually have to do with how tall the coupler of the trailer is from the ground. The Draw-Tite #76020 will sit at 13 1/2 inches from the ground to the top of the hitch when installed on a 2016 Mazda CX-9. From what I could find…

view full answer...

Answer 10

Yes, a trailer that is nose up can cause big problems. A level trailer is ideal and worth working toward for safety. The good news is that you can get the trailer almost exactly level with switching ball mounts. This is where an adjustable ball mount…

view full answer...

Answer 11

Hey HPA, I would go with the Air Lift kit part #AL64VJ that fits your 2019 Toyota RAV4 based on what you described and your needs. This gives you adjustable support that you can tailor as needed so that you get the exact amount of support you need…

view full answer...

Answer 12

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

view full answer...

Can Adjustable Ball Mount with Sway Control Tab # 7390 be Used with Left or Right Side Sway Control

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching