Replacement Lead Leg For Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System  

No, the hall effect motor does not have to be greased, but per the service manual if the jacks are down for an extended period, it is recommended to spray the exposed leveling jack tubes with lubricant every 3 months for protection. If you live in a…

The distance between the insides of the weld stops on the jack leg #LC362485 is 17-1/2 inches and the outer tube diameter is 2-1/2 inch by 2-1/2 inch.

I spoke to Lippert and they said to check a few things. First, they did say to double check the battery and make sure it is not dropping under 12 volts. The system will always draw from the battery, even when attached to shore power, and the…

We had a customer with same scenario as you get back with us and let us know what it took to get the auto level function to work. It appears you have to press a "arrow" button before you press the "auto level" button. I ran this…

This has been asked before, and what Lippert has told us is that in order to turn your 4-point system #LC358590 to a 6-point system #LC675817 you'd have to purchase the entire new 6-point system, unfortunately. The two additional jack legs can…

With your Lippert Ground Control 3.0 #LC358590, since you have power to the unit confirmed and have already disconnected the touch pad and controller letting them remain disconnected for more than 15 minutes for reset, you will most likely need to…

For the Lippert Ground Control 3.0 Trailer Leveling System #LC358590 we do offer the front leg only with part #LC362485.

I checked with Lippert, and the error like the LF error you are getting on your Lippert Ground Control 3.0 - 4-Point Set #LC358590 is typically caused by a wiring interruption. So according to them, you'll want to check the harness connections at…

I spoke with my contact at Lippert and he informed me that the lights flashing indicate the low point of the coach and that if you perform a zero point calibration you will correct that. In the service manual you will need to follow the instructions…

In regards to the Lippert Ground Control 3.0 Leveling System (what you were looking at), there are no replacement inner tubes available. Therefore, if you bent the inner tube on the front leg then you will need to replace the entire leg for which we…

The Lippert Ground Control leveling system #LC358590 will work well for you. The 4-points of stability and leveling are going to provide a more stable feeling when you are in the trailer without the additional expense of a 6-point system. As long as…

My contact at Lippert Components confirmed that the mounting brackets in their Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC358590 gets bolted in place. The only welding that may be required is if the frame brackets for the front…