How Far Does Gen-Y Torsion 2-Ball Mount 325-GH-1324 Hang Under Receiver
Question:
How low does the hitch hang below the receiver
asked by: Patrick
Expert Reply:
The distance will be 12-1/4 inches from the bottom of your 2-1/2 inch receiver to the bottom of the Gen-Y torsion ball mount you asked about, which is the following part number:
- Gen-Y Torsion 2-Ball Mount w/ Stacked Receivers - 2-1/2" Hitch - 6" Drop/Rise - 21K # 325-GH-1324
I do highly recommend a lock set to lock the ball mount to your hitch, as well as the platform to the ball mount, by adding the InfiniteRule Lock Set for Gen-Y 21K Adjustable Ball Mounts for 2-1/2" Hitches # 34061651-D.
Products Referenced in This Question
Gen-Y Torsion 2-Ball Mount - 2-1/2" Hitch - 3" Rise/6" Drop - 21K
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- 2 Inch Ball
- 2-5/16 Inch Ball
- Two Balls
- Steel Ball
- Steel Shank - Gray
- Drop - 6 Inch
- Rise - 3 Inch
- Fits 2-1/2 Inch Hitch
- 21000 lbs GTW
- Class V
- Built-In Pintle Hook
- Shock Absorbing
- Stacked Receivers
- Gen-Y Hitch
more information >
Product Page this Question was Asked From
InfiniteRule Lock Set for Gen-Y 21K Adjustable Ball Mounts for 2-1/2" Hitches - Qty 3
- Accessories and Parts
- Drop Hitch
- Trailer Hitch Ball Mount
- Locks
- Locking Pin
- InfiniteRule
more information >
Continue Researching
- Article: Rust Prevention
- Q&A: Best Lock Set For 21,000 lb Gen-Y Adjustable 2-Ball Mount For 2-1/2 Inch Hitch
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: What Length of Hitch Pin Lock for Holding Attachment into Gen-Y Adjustable Ball Mount
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Does Installing A Wiring Harness On A 2021 Jeep Wrangler JL Require A Wire Run To The Battery?
- Q&A: Replacement Crank Handle For the Lippert Spare Tire Winch with Offset Cable
- Q&A: Recommendation For Using Bike Rack With Roadmaster Spare Tire Carrier w/o Reducing Ground Clearance
- Q&A: Why Doesnt etrailer Hitch Lock # e98881 Have Shear Strength Capacity Listed
- Q&A: What Percent of a 5th Wheel Trailer King Pin Should be the Tongue Weight
- Article: How to Install E-Track in 3 Easy Steps
- Article: Using a Portable Generator on RV
- Article: Determining Trailer Tongue Weight
- Article: How to Mount a Truck Bed Camper