Is There a Replacement Mounting Bracket Available For a Furrion FOD43TA-BL Monitor

Question

Question:

I bought a camper that has a Furrion backup camera. I have the monitor FOD43TA-BL but do not have anything to mount it to the windshield. I bet I need a monitor bracket and a suction cup base. Can you help me?

asked by: Dana M

0

Expert Reply:

Replacing your camera system with the Furrion Vision S Wireless RV Backup Camera System # FOS43TASF is the only thing I can recommend for you. Furrion discontinued your FOD43TA-BL and all the parts for it as they changed the technology used for the cameras to communicate. For that reason you must replace the entire camera system and cannot get a new monitor with a new mounting bracket. Your monitor had a mount that clamped around the monitor while the new cameras have a socket in the back of the monitor for the new Suction Cup Mount # FR79SR to fit.

expert reply by: Bud M

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 3

I went out to the warehouse and measured the ball size of the Replacement Suction Cup Mount for Furrion Vision S Wireless RV Backup Camera or Observation System part #FR79SR for the 5" and 7" screens and it measures .85".

view full answer...

Answer 4

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 5

The Furrion cameras, like what comes in the part #FOS43TASF that replaced the part you referenced, are only compatible with their specific monitors. If you are looking for a camera system that allows you to use your smartphone as the monitor then I…

view full answer...

Answer 6

I checked with Furrion and the 7 inch and 5 inch monitor version of the Furrion observation system #FOS05TASF use part #FR79SR. The smaller 4.3 inch size use the part #LC776462. The ball of the #FR79SR is 0.85" or 21.59mm and the ball of the…

view full answer...

Answer 7

The ball diameter on the Replacement Suction Cup Mount for Furrion Vision S 5" and 7" Monitors #FR79SR is .85". I have attached a product overview video as well as a diagram for you to check out as well.

view full answer...

Answer 8

The #FRCBRKT-BL is actually the mounting bracket but it will still be the Furrion Vision S Wireless RV Backup Camera #FCN48TASF mounted on your bracket. Your camera is compatible with the Replacement 4.3" Monitor for Furrion Vision S Wireless RV…

view full answer...