20 inch Long Lift Gas Shock Lift with 100 lb Force

Question

Question:

I need a 20 inch 100 pound lift for my bay door. What would be my part number?

asked by: Jim

0

Expert Reply:

For a 20 inch long gas shock with 100 lb lift force we have the part # 372-2300-100 which would work great.

expert reply by: Jameson C

0

Answer 1

We have gas shocks for trailer doors, and I can tell you how to determine the correct one for your trailer, but wouldn't have any way of knowing the exact one you need. To determine the correct one though, all you have to do is measure you…

view full answer...

Answer 2

Since you mentioned 80 lb shocks being inadequate, I'll go ahead and give you gas shocks with at least 100 lbs of force that are 20 inches long. I don't have any way of knowing what mounting hardware you have, but I can tell you each…

view full answer...

Answer 3

JR Products, like the Gas Shock #372-2300-150 you mentioned, are manufactured 100% in the United States.

view full answer...

Answer 4

Typically the existing shock is a good way to determine what is needed for replacement; the weight of the door being held, the length of the shock and the angle they're installed at all have effect on the force required to close the door. In most…

view full answer...

Answer 5

The highest rated gas shock absorber we offer is the JR Products Gas Shock part #372-2300-150 which measures 20" extended and 1.41" compressed or part #372-7145 which measures 26.32" extended and 15.82" compressed. These shocks…

view full answer...

Answer 6

There are many factors that go into selecting the correct gas shock, the easiest would be to simply match the new shock with the existing using any labels printed on the body. If none are present or you are adding a new one then you can use a formula…

view full answer...

Answer 7

I reached out to Lippert and your 346005 control module was replaced with the Replacement Control Module for Lippert Ground Control 3.0 Leveling System #LC85ED. To use this control module they said you must have the Control Panel #LC421484 otherwise…

view full answer...

Answer 8

There may be a bunch of different reason why your Lippert Level-Up system has suddenly stopped working. The most common reasons are due to a dead battery, extending your jacks too far, or a blown fuse. The first thing you should check for is the easy…

view full answer...

Answer 9

If the touch pad is showing "Retract Time out Return Levelers for service" all you need to do is hit, enter and retract at the same time. That will clear that code. I confirmed this with our contacts at Lippert. Let me know if that fixes…

view full answer...

Answer 10

For replacement install brackets for the Firestone Ride Rite Kit part #F2525 you'll need the following brackets: Replacement Upper Bracket #F5699 Replacement Bracket #F5701 Replacement Bracket #F5700 Replacement Bracket #F5702

view full answer...

Answer 11

If it is necessary to lift your 2012 Ford F-150 by the frame, first release the air pressure from the Firestone Ride-Rite Air Helper Springs #F2542. This will allow the air springs to extend to their maximum length without being damaged. The…

view full answer...

Answer 12

For installing the Firestone Ride-Rite Air Helper Springs - Double Convoluted #F2542 on your 2012 F-150 with a 2-inch lift, you will need spacers to accommodate the raised height of your frame. The spacers you need for a 2-inch lift is the Lift…

view full answer...