How To Connect The MaxxFan Roof Vent To Power On A 2016 Jayco Jay Feather TT

Question

Question:

Existing roof vent has no fan. I would like to replace with a MaxxAir 4 speed fan. Would there likely be unused wiring in the ceiling for this connection? If not, how would I run wiring to the new vent fan? Thank you! 2016 Jayco Jay Feather Travel Trailer.

asked by: Sheridan S

0

Expert Reply:

The MaxxFan Roof Vent w/ 12V Fan # MA00A04301K only has two wires to connect; a positive and a negative. Since this is a new install, and that there is no preexisting wiring from a previous fan, there would be no unused wiring.

To connect # MA00A04301K to your 2016 Jayco Jay Feather TT, you will just need to use the provided 16 AWG insulated connectors to connect the trailer's 12 volt power to the two wires.

The black wire should be labeled, but if it isn't, this wire is your positive wire, and the white wire is your negative wire.

I have attached an installation video for you to check out, you can skip to 11:22 in the video to see the portion going over making these electrical connections.

expert reply by: Bryce D

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 3

We do offer a direct replacement for the Dometic Duo-Therm RV Air Conditioner. The Advent Air RV Air Conditioner part #ACM135 for 13.5K or part #ACM150 for 15K is what I recommend. This unit will be a plug and play fit and it will work with your…

view full answer...

Answer 4

If your Ford F-450 has an actual bed and is not a cab and chassis model (with a service bed or flatbed) then you can use the Curt universal folding gooseneck ball rail kit #C61502. You could then use Curt hitch #C-52 or #C65500. A custom hitch for a…

view full answer...

Answer 5

The Carrier Air V RV Air Conditioner is no longer produced so a direct replacement of the same unit is not an option. However, we do have available the two Advent AC models that are designed as replacement units for the Carrier Air V. I recommend…

view full answer...

Answer 6

Advent Air Conditioners like part #ACM135 come with a connector that pairs up directly with the standard 6-wire connector. If you have a 9-wire connector then you need the kit #ACRG15 as well. For wiring I'm attaching some photos of diagrams for…

view full answer...

Answer 7

Hi Robert, If you're just wanting to replace the condenser unit on the rooftop and retain use of your current air distribution box and thermostat then you'll just need to determine what style connector your current unit has. If you remove the…

view full answer...

Answer 8

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...