What Replacement Snap Pads Will Work With My Lippert Ground Control 3.0 9 Inch Round Feet

Question

Question:

We have the Lippert Ground Control 3.0 jacks on our 2021 Keystone Laredo 5th wheel. The jack feet on the back are 9 in. round but the front are 8 1/2 to 8 3/4 in. round. Will the 9 in. Snap Pad fit both front and back with the difference in sizes? Thank you.

asked by: Katie B

1

Helpful Expert Reply:

When it comes to replacing your snap pads for your 9 inch round Lippert Ground Control 3.0 on your 2021 Keystone Laredo The SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet - Qty 4 # SP54FR4 is what you need. They will fit your front feet that measure between 8-1/2 inches to 8-3/4 inches. These heavy-duty rubber pads snap onto your Lippert leveling jacks to make leveling faster, it also helps dampen vibration from inside the motorhome that could cause shifting.

I have attached a review video link below.

expert reply by: Noah E

1

Answer 1

We do offer the 9" snap pads like SnapPad Jack Pads part #SP54FR6. Depending on whether you have a 5th wheel or a motorhome there is a slight difference between them but I would be happy to help you select the correct ones if you provide that…

view full answer...

Answer 2

If you're wanting to add a snap pad to a 9" round landing gear the Replacement Pad for SnapPad Jack Stand Pad System - 9" Round Jack Foot Item #SP54FR is what you need. If you need a different size or shape I've attached the page…

view full answer...

Answer 3

As long as your Andersen Blocks are 9" in diameter and have a lip of around 1/8" you should be fine using the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet - Qty 4 Item #SP54FR4. If you have issues keeping…

view full answer...

Answer 4

I checked the parts list for the Ground Control 3.0 Electric Leveling System #LC358590 (4-Point Set) or #LC675817 (6-Point Set) and the jack tube by itself is not available as a replacement part. Due to that if you need a replacement leg you will…

view full answer...

Answer 5

Your leveling system is not supposed to lift the wheels off the ground; this could exceed the capacity of your leveling system and cause damage and I do not recommend doing so. If you can make any adjustments to the legs then you will want to go…

view full answer...

Answer 6

I do see that the Lippert Ground Control #LC358590 leveling system was an option on the 2019 Grand Design Reflection 150 295RL 5th wheel camper so you will not have any fit issues with the leveling system. There are some campers that are unable to…

view full answer...

Answer 7

I did some research based off the information you gave me, I have linked some items below: **Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch - Remote - 2,000 Watts - 12V #PD64FR. *Go Power Industrial Pure Sine Wave Inverter Charger -…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The SnapPad Jack Stand Pads like part #SP54FR4 may still work with the Steady Fast or JT Strong Arm Stabilizers but you'd likely need to trim the pad where the arm attaches or raise the arm up a bit from the pads. There is a lip on the pads that…

view full answer...

Answer 11

There are not replacement internal parts for the Ground Control System. You will need to replace the whole leg. We offer both Left #LC305339 and Right #LC344792 rear legs as well as the Lead leg #LC305340 for either front leg replacement. Since you…

view full answer...

Answer 12

Thanks so much for the photo, it was very helpful. Based on that the correct replacement leg for the Lippert Ground Control 3.0 Electric Leveling System #LC358590 on your Keystone Cougar is actually going to be the Replacement Left Rear Leg…

view full answer...

What Replacement Snap Pads Will Work With My Lippert Ground Control 3.0 9 Inch Round Feet

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching