Dimensions Of Atwood Replacement Water Heater Door AT91386 For 6 Gallon Water Heaters

Question

Question:

What is the size in inches of the Replacement Door for Atwood RV Water Heaters - 6 Gallon - Arctic White Item # AT91386

asked by: Keith H

0

Expert Reply:

The Replacement Door for Atwood RV Water Heaters # AT91386 is 18" wide and 14-1/2" tall(see image). This is a replacement for Atwood model AT96110, AT96163, AT96121, and AT96136 6 gallon water heaters.

We also have the Water Heater Door Latch # 372225 that you may need to replace with the door if it is damaged and no longer securing the door in place while you drive down the road.

expert reply by: Bud M

0

Replacement Door for Atwood RV Water Heaters # AT91386 Dimensions
(click to enlarge)

Answer 1

We have checked with Atwood and can confirm for you that the Replacement Black Door #AT91507 or white #AT91386 are a confirmed fit for your 6 gallon Atwood GC6AA-10E water heater.

view full answer...

Answer 2

The RV water heater door part #AT91386 does not come with mounting hardware so for that you'd need the cam locks like part #CAM09213 and you'd be set.

view full answer...

Answer 3

I went out to our warehouse to take a look at the Atwood Replacement RV Water Heater Door #AT91386 referenced in your question. The door measures 18 inches wide and right at 14-1/2 inches tall. This particular replacement door is designed for the…

view full answer...

Answer 4

For your Atwood GC6AA-9E water heater, you can use the: -Dometic RV Water Heater #DMC74FR as a replacement. This water heater has a heating capacity of 10,000Btu's, a 6 gallon tank, and operates on 120VAC. Additionally, the installation and…

view full answer...

Answer 5

There sure is! We have the Furrion RV Tankless Water Heater #FR98SR which fits has an overall size of 19-3/16" deep x 12-5/8" tall x 12-13/16" wide and an access door size of 16-1/8" tall x 16-1/8" wide so it will be a…

view full answer...

Answer 6

The Dometic RV Water Heater #DMC74FR uses a different Door #DMC58FR than the one on your Atwood water heater. The vent and latches are in different locations on the doors. You may be able to have just the door paint matched at your local paint shop…

view full answer...

Answer 7

The #FR48SR will not mount correctly to your Atwood GC6AA-10E but Atwood has confirmed that the Replacement Door for Atwood RV Water Heaters - 6 Gallon - Arctic White Item #AT91386 will fit.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...