Recommended Anti-Sway Bars And Steering Stabilizer For A 2007 Four Winds Hurricane Class A Motorhome

Question

Question:

Looking to purchase front and rear anti sway bars, steering stabilizer and bushing kit for rear factory sway bar. Will be installing on 2007 Four Winds Hurricane / 31 ft. / GVWH 18000. Please forward info on what would be recommended parts. Thanks

asked by: Dave M

0

Expert Reply:

Since you have an F-53 Chassis on your 2007 Four Winds Hurricane Class A Motorhome you'll need the following products:

Front: Roadmaster Front Anti-Sway Bar # RM-1139-148.

Rear: Roadmaster Rear Anti-Sway Bar # RM-1139-146.

Steering Stabilizer:

If you have an R-Series chassis you'll need the Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets for Class A Motorhomes # RM88RR.

If you have a W18 chassis you'll need the Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets for Class A Motorhomes # RM68RR.

expert reply by: Kevin C

0

Answer 1

Since your 2021 Coachmen Mirada 29FW has an 18k GVWR the correct sway bars you will need are the #RM-1139-146 for the rear bar and #RM-1139-148 for the front. I attached install videos for both of these for you to check out as well.

view full answer...

Answer 2

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Answer 3

In regards to steering and keeping the wheel centered, the Roadmaster Exact Center Steering Stabilizer part #RM47MR will work great for this on a 2022 Ford E-450 Chassis. The stabilizer is basically a spring that returns the wheel to center when not…

view full answer...

Answer 4

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

view full answer...

Answer 5

If the U-bolts are 9/16 inch diameter, the torque specs should be between 65 to 95 foot lbs. If the U-bolts are 3/8 inch diameter, the torque should be between 30 and 50 foot lbs.

view full answer...

Answer 6

The Roadmaster #RM-1139-140 and #RM-1139-148 are both replacement anti-sway bars for a Ford F550 or F53 Class A motorhome chassis. Both bars are 1-3/4 inches in diameter. The #RM-1139-140 fits models with a GVWR of 22K-24K, and the #RM-1139-148 fits…

view full answer...

Answer 7

You are certainly not alone in looking for a way to reduce the amount of sway and body roll when driving a motor home but there are great solutions to remedy those white-knuckle moments when going side-by-side with a semi or meeting crosswinds. The…

view full answer...

Answer 8

The biggest improvement you can make in handling and stability for motorhomes built on a 2017 Ford F-53 chassis is with a rear sway bar like the part #RM-1139-146 which is correct for your motorhome and your 18k GVWR. Next up you'd want to…

view full answer...

Answer 9

For your 2023 Coachmen Pursuit 31BH you will need the Front SumoSprings Rebel Custom Helper Springs #SSF-170-40-2 and Rear SumoSprings Maxim Custom Helper Springs #SSR-184-40-1. If you were to select only one to install first I recommend the rear…

view full answer...

Answer 10

Roadmaster Rear Anti-Sway Bar part #RM-1139-146 can only be installed in one orientation. It is not designed to be installed upside down. I have attached a photo of what the installation should look like.

view full answer...

Recommended Anti-Sway Bars And Steering Stabilizer For A 2007 Four Winds Hurricane Class A Motorhome

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching