Can 30 Amp Side of Power Grip RV Power Maximizer part # CAM55025 Handle 240 Volts  

I reached out to a representative of Camco who said the Power Grip RV Power Maximizer - 50 Amp Female to 15 Amp Male and 30 Amp Male #CAM55025 does have the ground and neutrals wired together. They said it would work on outlets so long as it is not a…

Yes, you can plug the Camco Power Grip RV Power Maximizer #CAM55025 into your RV's 50 amp service and just use one of the two plugs at the other end. The two adapter plugs are wired independently so you can indeed just treat the unit as separate…

The Camco Power Grip RV Power Maximizer, part #CAM55025 can be used with the 110 plug only or with the 30 Amp plug only, or with both when you have the receptacles available. Using just the plug in a 110 receptacle will limit the input to 15 amps so…

For your 2018 Wildcat 262RGX with 50 amp service, I recommend the Camco RV Power Defender Circuit Analyzer Dogbone - 125V - 50 Amp #CAM55313. This will prevent your system from a surge that could hurt your trailer's electrical components. This…

Yes, you can run the Camco RV Power Defender Voltage Monitor - 50 Amp, #CAM55306 in line to a 30 amp shore recepticle. It will provide you with the protection from power surges and excessive voltage. It has a diagnostic center that's going to be…

No, the 15 amp and 30 amp ends are wired separately to the 50 amp female plug on the Camco Power Grip RV Power Maximizer, #CAM55025. These power wires connect to the 50 amp plug at separate poles allowing you to have 45 amps to you 50 amp trailer…

We offer many RV wiring adapter items that can allow connecting 50-amp devices to 30-amp service at an RV park. I think the item that was mentioned to you is the CAMCO Power Grip RV Power Maximizer #CAM55025. This is a Y-type adapter cord that on one…

Yes, the Camco Power Grip #CAM55025 will work if you plug in both the 30 amp male and 15 amp male into your generator.

The Power Grip RV Power Maximizer - 50 Amp Female to 15 Amp Male and 30 Amp Male #CAM55025 is not compatible with a GFI because of the function of the outlet. I reached out to my contact at Camco and they said lack of a completed uninterrupted ground…

Yes, you can use a 30 amp to 50 amp dogbone adapter like the Mighty Cord Dogbone RV Power Cord Adapter part #A10-5030FBK on a trailer with 30 amp surge protector.

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…