Bolt-On Trailer Hitch Receiver For Vanleigh Vilano Trailer

Question

Question:

I have asked Vanleigh about this but not getting an answer. I have a 2020 Vanleigh Vilano 370GB. I want to put a receiver hitch under or in front of the rear bumper to use for a bike rack. It has tabs on either side 72 inches apart with predrilled holes 8 inches on center. I would like a bolt on application. Suggestions?

asked by: Phil H

0

Expert Reply:

There is a single option for a trailer hitch receiver for your 2020 Vanleigh Vilano with its 72" spacing, which is a hitch from Curt:

- Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide # 13703

This is a complete bolt-on hitch like you were wanting and has a 2" receiver for your bike rack.

expert reply by: Kyle S

0

Answer 1

I spoke with Lippert about the Trailer Hitch Receiver for Vanleigh 5th Wheel Trailers part #LC730647 and they said this would work on your 2018 Vanleigh Vilano if the distance between your two frame rails inside to inside is 72". If this…

view full answer...

Answer 2

The Lippert 2" Trailer Hitch Receiver part #LC730647 is specific to Vanleigh 5th Wheel Trailers. If you take a look at the attached photo you will see that there are tabs on this trailer that sit below the frame and the trailer hitch attaches to…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 7

Hey Dave, so the best option for carrying your carbon frame bike and e-bike is the Swagman Escapee part #S39SR with the ramp #S59SR . It has the capacity for carrying an e-bike, is rated for travel trailer use, only touches the bikes by the tires…

view full answer...

Answer 8

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

view full answer...

Answer 9

The puck feet on the Gen-Y Hitch Gooseneck Trailer Hitch for Dodge Ram OEM Puck Systems #GY83XR is just to help stabilize the ball mount and does not lock into place in the puck. The locking mechanism on top will lock the shank into the gooseneck…

view full answer...

Answer 10

RVs in general have a much rougher ride quality than vehicles due to the less sophisticated suspension (mostly trailer) but also the much longer length between the rear axle of the motorhome and the rear bumper. This exaggerates the movement from…

view full answer...