Could MORryde Cord Storage Reel Work with 35 Foot Long Cord

Question

Question:

I know it says 30ft but, mine is a 35ft 50 amp

asked by: Travis E

0

Expert Reply:

You can still use the MORryde Manual Cord Storage Reel for 30' Long Power Cords # MR77RR with a 35 foot long cord but the last 5 feet wouldn't get rolled up, so you'd have to set that portion next to the reel.

expert reply by: Jameson C

0

Answer 1

I spoke with the manufacturer, MORyde, and the MORryde Manual Storage Reel for 30' Long Power Cords - 13-7/16" Tall #MR77RR has a shipping weight of 16lbs, product actually weighs 15lbs.

view full answer...

Answer 2

The MORryde Manual Storage Reel for 50' Long Power Cords #MR77RR should only be mounted to the floor of your storage area.

view full answer...

Answer 3

Per the Nissan Titan brochure for 2018, the Nissan Titan XD Diesel 4x4 crew cab has a 2,080lb maximum payload. Golf carts are about 1,000lbs usually and are typically right at 8 feet in length. If your truck bed is 8 feet you will have most likely…

view full answer...

Answer 4

For getting your trike up onto a trailer, using the #288-07452-2 along with the #288-07452 ramps as you've proposed would be the best bet, and would be what I'd recommend. The combined capacity of the ramps would handle the weight of your…

view full answer...

Answer 5

If the end of the power cord was permanently attached to the coach, you'd have to put in the opposite end of the cord into the MORryde Cord Storage Reel #MR77RR which would then roll it up basically backwards.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Could MORryde Cord Storage Reel Work with 35 Foot Long Cord

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching