2021 Toyota Sequoia Front Mount Hitch Fitment with Skid Plate

Question

Question:

I have a 2021 Toyota Sequoia TRD Pro. Are there any front hitch mounts that will work with the TRD Pro skid plate. Heard that can be an issue. Thanks,

asked by: Mark

0

Expert Reply:

Both the Draw-Tite # 65080 and Curt # 31198 front mount hitches can still be installed if your 2021 Toyota Sequoia has that front skid plate, but it does require removal and trimming during the installation. So it fits, it just doesn't fit right up into place.

Attached is an installation video of the Curt front hitch installed on a 2019 Sequoia for you to check out.

expert reply by: Jon G

0

Answer 1

Starting with the tow hooks, those will remain on your 2020 Toyota Tundra when installing the Draw-Tite Front Mount Trailer Hitch Receiver #65080. They will be temporarily removed, but will be bolted back on. In regards to the hole, there is a small…

view full answer...

Answer 2

According to Curt, if the truck is equipped with the skid plate, the skid plate will need to be removed or have the 4 inch diameter hole cut into it to allow for oil changes. The hitch cannot be removed each time the oil needs changing, because the…

view full answer...

Answer 3

The Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2" #65080 is my recommendation for you based on cost and features. The installation of this hitch is nearly identical to the Curt #31198. The Draw-Tite has a measurement of 7-1/2…

view full answer...

Answer 4

I was able to get the measurements you were looking for of the Draw-Tite front mount hitch that fits your 2020 Toyota Tundra, which is the following: - Draw-Tite Front Mount Trailer Hitch Receiver #65080 The hitch is similar to the Curt #31198 in…

view full answer...

Answer 5

For your 2018 Toyota Tundra we have the Curt front hitch part #31198 and the Draw Tite part #65080 both as a confirmed fit and both really good options. Both install the exact same and have same capacities, but I like the Curt better as it's made…

view full answer...

Answer 6

The biggest difference between the Curt front hitch part #31198 and Draw-tite front hitch part #65080 is that the Draw-tite receiver tube extends out more than the Curt by over an inch. This makes it more visible when nothing is mounted to it.…

view full answer...

Answer 7

There is a 4 inch diameter hole that needs to be cut in the skid shield of your 2016 Toyota Tundra to be able to install the Draw Tite front hitch part #65080 that you referenced. I attached a diagram that shows where it will be.

view full answer...

Answer 8

Curt RV frame mount hitch #13703 has a tongue weight capacity of 350 pounds. So the Honda Ruckus would be fine but the Suzuki would be too heavy since you also have to factor in the weight of a carrier. With this hitch Curt also says you have to use…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

You can use that upper hole on your hanger to install the #MR33WR. Make sure you don't tighten it down too much or you will pinch the leaf spring and it won't function properly. You will also need to make sure you have enough room to install…

view full answer...

Answer 11

It's hard to say without knowing which bolts you have but if you can reverse the directions of the bolts that sounds like it's the problem. It would be worth checking at least to see if the bolts will go all the way flush going in from the…

view full answer...

Answer 12

There's quite a bit of variance in how the gas line of your 2021 Keystone Cougar can be ran and how it would need to be repositioned to to install the SumoSprings part #SS26MV which is why their included relocation kit offers several ways it can…

view full answer...

2021 Toyota Sequoia Front Mount Hitch Fitment with Skid Plate

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching