How Can I Improve Wind Resistance on My Redarc Solor Panel # RED66VR?

Question

Question:

I have a Redarc solor panel RED66VR installed and I am getting a lot of wind noise. Is there anything I can install to reduce the noise?

asked by: John C

0

Expert Reply:

In order to greatly reduce the noise on your Redard Solor Panel # RED66VR, I recommend installing the Redarc Solar Panel Wind Fairing Mounts - Qty 2 # RED29VR. With the fairings, they provide the wind resistance you need in order to decrease the amount of noise during transport. They mount to your panel with adhesive or common fasteners.

expert reply by: Bob C

0

Answer 1

I reached out to my contact at Progress Mfg. about your question. They do not have a longer lever bar and they do not recommend using what I would call a "cheater bar" to extend that bar for greater leverage. They suggested that when you…

view full answer...

Answer 2

I'm assuming you mean the length of the Snap-Up Lever for Fastway e2 Weight Distribution Systems #FA92-00-6000. It is 19.5" long. If you're asking about capacity it doesn't have anything specific but is capable of handling any…

view full answer...

Answer 3

Yes, when installing the Adjustable Mount Kit #34244034 that allows you to tilt the Go Power 100 Watt Solar Panels on your trailer, the existing L-brackets on the roof will need to be replaced with the L-brackets included with the kit. Keep in mind…

view full answer...

Answer 4

For a similar style light to the glo brite you mentioned, I recommend using the Thinline LED Trailer Tail Light w/Reflector #STL69RRXB which has tail, turn and brake light functions. This light is 15" long and 1-5/8" wide; the mounting…

view full answer...

Answer 5

To change the battery mode on the Progressive Dynamics 9300 Series RV Converter Charger #PD79RR you'll need to insert the included CLAW tool into the small opening next to the battery type indicator light. Press and hold that button (using the…

view full answer...

Answer 6

The Redarc Solar Panel Corner Mounts part #RED79VR can be attached either by screws or adhesive. I don't have an exact adhesive brand per se but Redarc recommends silicone adhesive which is common and can be found locally. The most secure method…

view full answer...

Answer 7

From what I could find on your Valeigh Beacon 34RLB 5th wheel it is 13'1" tall (13.08). The Lippert On-The-Go Telescopic Ladder #LC64HD you were looking at is only 12-1/2' tall, so it would not be tall enough to reach the top of your 5th…

view full answer...

Answer 8

The 101000156 part number you reference has to do with a motor which fits a variety of systems. In order to determine which replacement leg you're going to need for your landing gear, I am going to need to know what specific system you have. For…

view full answer...

Answer 9

I do have a solution for you, however we do not have just the inner tank components available as replacement parts. The best option I can offer you is a full replacement for your water heater. To replace your older model SW6DE I highly recommend the…

view full answer...

Answer 10

Since you're not receiving power on the blue controller wires of your Furrion RV Tankless Water Heater #FR93FR the cause is most likely an issue with the power coming into the unit itself or just a bad ground. First, be sure that the power switch…

view full answer...

Answer 11

With the Go Power Portable Solar System with Digital Solar Controller part #34282730 the limiting factor would be the solar controller in this case it is a 10 Amp. Adding a 180 Watt panel would cause this to be overloaded. The largest portable we…

view full answer...

How Can I Improve Wind Resistance on My Redarc Solor Panel # RED66VR?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching